BLAUPUNKT GT100 Vehicle Tracking System Instruction Manual

: June 3, 2024
: Blaupunkt

Table of Contents

BLAUPUNKT GT100 Vehicle Tracking System
CAUTIONS
STRUCTURE & FUNCTIONS
SPECIFICATIONS
FUNCTION LIST OF THE DEVICE
WIRING DIAGRAM
TROUBLESHOOTING
OPERATION INSTRUCTION
DIFFERENT SCENARIO
SOFTWARE OPERATION
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

BLAUPUNKT GT100 Vehicle Tracking System

BLAUPUNKT-GT100-Vehicle-Tracking-System-PRODUCT

CAUTIONS

Safety Notes
This device has been manufactured according to established safety guidelines. However, dangers may still occur if the safety notes in this manual is not observed. This manual is intended to familiarize the user with the device’s import-ant functions. Read this carefully, prior to using the device. Keep this manual in an easily accessible location. In addition, do observe the instructions of the devices used in conjunction with this device.

Attentions

This device is intended for installation and operation in a vehicle with 12V and 24V vehicle system voltage.
Keep the device away from children.
Keep the device away from flammable areas or liquids.
The device should be stored in dry and low humidity place.
Ensure the car battery is fully charged.
Weak signal or signal interference of device can arise from obstacle locations such as underground parking.
For abnormalities, please refer to the “Troubleshooting” section. Consult with Blaupunkt dealer for further assistance, in case if the problem cannot be resolved

This manual may be updated from time to time without any notice. Visit www.blaupunkt.com/ase for latest info.

Disclaimer
In no event shall Blaupunkt be liable for any direct, indirect, punitive, incidental, special consequential damages to property or life and whatsoever arising out of or connected with the use or misuse of our products.

USA & CANADA : This product is not intended for sale in the United States and Canada. If purchased in the U.S. or Canada, this product is purchased on as-is basis. No
warranty, whether expressed or implied is provided in the U.S. or Canada. Blaupunkt does not warrant the performance of the local telecommunication network used with our product. It is recommended to test for network compatibility prior to purchase.

STRUCTURE & FUNCTIONS

BLAUPUNKT-GT100-Vehicle-Tracking-System-FIGG-1

Functions

Indicator light of GSM
Indicator light of GPS
Switch (On/Off)
SIM card slot
Light sensor

SPECIFICATIONS

Operating Voltage : DC 9V-36V
Current : 10mA
Navigation System : GPS
Location Accuracy : Up to10 meters
GSM Frequency : 850/900/1800/1900MHz
Internet Protocol : TCP
Working Temperature : -25°C ~ +75°C
Storage Temperature : -40°C ~ +85°C
Standby Battery : 0.5 Hours
Dimension (LxWxH) : 78.5x23x12mm

FUNCTION LIST OF THE DEVICE

Functions	Details	Descriptions

Vehicle Status

Detection

| Acc On/ Off| Uploaded data include the Acc On/ Off status each time in dynamic view.

Alarm Notification

| External Power Disconnection| When the vehicle voltage is <5V, vehicle battery consumption is stopped. When the backup battery of device is depleted, the tracking

function will be disconnected.

Low External Battery| Vehicle battery voltage is between 5V to 10V. It is an indicate that the

vehicle battery is low.

External Power

Supply

| Power is supplied to the device.
External Power

Disconnection

| Power supply has been disconnected

from the device.

Enter Fence| The vehicle enters the defined area

set by user.

Leave Fence| The vehicle leaves the defined area

set by user.

Speeding Start| Vehicle speed exceeds value set.

Default is 120km/hr for 10 seconds.

Speeding End| Vehicle speed is below value set after

speeding is detected.

WIRING DIAGRAM

BLAUPUNKT-GT100-Vehicle-Tracking-System-FIGG-2

TROUBLESHOOTING

If any of the following problem occur, please resort to Troubleshooting for the possible solutions. Consult Blaupunkt authorized dealer if problem persist.

Problems	Possible Causes	Solutions
Weak or no GPS signal	GPS tracking device is not positioned properly.	Check

the installation location

of the device.

Ensure it is not being shielded

by metal.

The device is not respond- ing to SMS commands| SIM card has run out

of credit.

| Top up the SIM card.
Improper installation of SIM card.| Check whether the SIM card

has been slotted correctly.

Check that the SMS command

is correct.

OPERATION INSTRUCTION

Remove device cover and insert the SIM card into the SIM card slot and close back the device. (Ensure the SIM card has Internet access)
Tear off the 3M tape on the back of device and paste it inside the dashboard or car trunk