GLOBAL INDUSTRIAL Drum Palletizer Instruction Manual
- June 3, 2024
- GLOBAL INDUSTRIAL
Table of Contents
GLOBAL INDUSTRIAL Drum Palletizer
Note : The Owner/Operator must read carefully and understand all the information presented here before operation.
THANK YOU FOR USING THIS DRUM PALLERIZER. FOR YOUR SAFET AND CORRECT OPERATION, PLEASE CAREFULLY READ THIS INSTRUCTION BEFORE USING IT.
NOTE : All of the information reported herein is based on data available at the moment of printing. The factory reserves the right to modify its own products at any moment without notice and incurring in any sanction. So it is suggested to always verify possible updates.
SPECIFICATION
| Model | DJ365 |
|---|---|
| Capacity | 365kg / 800lbs |
| Acceptable Drum Style | 55 gallon, steel |
| Overall Size L×W×H | 125011001250 mm |
| Net Weight | 60kg |
| *Wheel (poly) DiaWidth** | D15050, D10032mm |
NOTICE
- Do not operate this pallerizer more than 70m/min speed when overloading.
- Do not operate the pallerizer unless you are trained and authorized.
- Please operate the pallerizer on the hard surface.
- Please push the drum when operating the pallerizer.
OPERATION
- Clamp the pawl handle for putting the handle on the top position.
- Push the drum near the pallet, the big hook button up the drum while two small hooks button up the side of drum, then pull the handle until the lowest position.
- When release the drum, press the handle down, then clamp the pawl handle and lower the handle slowly to put the drum on the ground
EXPLODED VIEW & PART LIST
| No. | Description | Qty | Remark |
|---|---|---|---|
| 1. | Split pin | 2 | Ф3.2*32 |
| 2. | Hook assembly | 1 | |
| 3. | Pipe core | 1 | |
| 4. | Handle assembly | 1 | |
| 5. | Left columniation | 1 | |
| 6. | Hex bolt | 2 | M12*80 |
| 7. | Flat washer | 4 | Ф12 |
| 8. | Hex nut | 2 | M12 |
| 9. | Pneumatic columniation | 1 | |
| 10. | Hex bolt | 4 | M10*70 |
| 11. | Flat washer | 8 | Ф10 |
| 12. | Hex nut | 4 | M10 |
| 13. | Wheel | 2 | Ф150 |
| 14. | Wheel shield | 2 | |
| 15. | Hex nut | 2 | M12 |
| 16. | Right columniation | 1 | |
| ※ | Pawl handle | 2 | |
| 17. | Pedestal | 1 | |
| 18. | Swivel wheel | 2 | Ф100 |
| 19. | Hex bolt | 8 | M10*20 |
| 20. | Flat washer | 8 | Ф10 |
| 21. | Spring washer | 8 | Ф10 |
NOTE : “※” had been contained in No 4 ( the hand assembly )
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>