SOLO Base Station User Manual
- June 3, 2024
- Solo
Table of Contents
SOLO Base Station
Solo Operation Manual – Pet Immune IR Motion Sensor
Legend
Bleed line
Trim line
Safety
Fold
Base Station
Station de Base
Estación de Base
Installation Guide
-
Program Registration
Before doing anything you must ensure that you have a valid EyezOn account. To set up your free EyezOn account go here www.eyezon.com select the CREATE ACCOUNT link at the top of the page and submit the form -
Log-In to EyezOn Account
Your EyezOn account is your management tool for your SOLO system. From www.eyezon.com select the LOGIN link and use the credentials sent you when you registered to proceed to your account. -
Install and Activate Device
Before powering on, record the 12 digit ID from the bottom of the device. From inside your EyezOn account select the AddNew Device link and follow the instructions choosing SOLO as the product type use the 12 digit ID from the bottom of the unit. -
Connect and Power On
See the diagram and instructions on the opposite page to complete the set up. For a complete guide to SOLO and your EyezOn account please navigate to the Help page within your EyezOn account. There you can find the step-by-step guide to setting up and maintaining your system.
To Connect
- Note: Before proceeding to the next steps, record the 12 digit ID from the sticker on the bottom of the module. Make sure you have created an EyezOn account and have activated the device using the 12-digit code (see opposite page).
- Plug in Solo base station to power source
- Connect the ethernet cable to modem
- Ensure you have the EyezOn App on your mobile device
The EyezOn App is available at:
This equipment has been tested and found to comply with the limits for a class
B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures Reorient or relocate the
receiving antenna Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected Consult the dealer or an experienced radio/TV
technician for help This device complies with Part 15 of the FCC Rules.
OperaIon is subject to the following two condiIons: (1) This device may not
cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this
equipment.
Industry Canada
This device contains license-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s license-exempt
RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>