Maxxima MCL-714805 Ceiling Light Installation Guide

Maxxima MCL-714805 Ceiling Light

WARNINGS

• Risk of electric shock – Disconnect power at fuse or circuit breaker before installing or servicing.
• Installation should be performed only by a qualified electrician
• Do not make or alter any holes in the wiring enclosure or modify any electrical componentry.
• Install only in environments ranging between -4F and + 104F.

CAUTIONS

• To ensure personal safety, proper grounding of the electrical fixture is required.
• The fixture must be wired in accordance with the National Electric Code and applicable local codes or ordinances.
• Suitable for dry and wet indoor and outdoor locations, use only 120VAC, 60Hz circuits.

INSTALLATION INSTRUCTIONS

1. Shut off power at the circuit breaker or fuse before installation.
2. If you are replacing an existing fixture, remove and disconnect the old fixture first.
   See installation options below: Junction Box Mounting:

3. Expose the existing wires from the junction box.
4. Connect the green and bare copper or green wires together then secure both ends of the bracket to the junction box using the provided screws. See Figure1.
5. Connect black (hot) wires together. Connect the white (neutral) wires together using the provided wire nuts. See figure 2.
6. Ensure the wires are placed properly within the junction box.
7. Secure the fixture to the mounting bracket. See figure 3

8. The installation is complete. Restore power to the fixture and verify the fixture operates properly.

Retrofit Mounting for 5in and 6in housings

•  Remove the green grounding wire from the bracket and attach the bracket to the light fixture. See Figure 4

• Attach springs to both sides of the mounting bracket using the provided screws. Ensure the springs are attached to the correct locations as shown in
  figure 5 and figure 6

•  Make sure the socket is accessible. Screw the E26 connector into the socket inside the can. Then connect the black (hot) wires together and connect the
  white (neutral) wires together using the provided wire nuts. See figure 7

• Bend the springs together and place inside designated latches inside of the can. See Figure 8

• Secure fixture up into the can until flush with the ceiling. See figure 9

• The installation is complete. Restore power to the fixture and verify the fixture operates properly.

3 YEAR WARRANTY

Maxxima extends a 3 year limited warranty to the original purchase that the products listed are free from defects in material and/or workmanship only. Maxxima will replace any warrantied product to the original consumer/purchaser if the product fails because of defects due to workmanship and/or materials within the limited warranty period. Limited warranty is not transferable and applies to the original installation of the Maxxima product. This offer does not constitute in any way a product guarantee and Maxxima does not hereby assume any obligation whatsoever beyond sending a free replacement product.

• info@maxximastyle.com
• 866-MAXXIMA (629-9462)
• www.maxximastyle.com
• 125 Cabot Court Hauppauge, NY 11788

References

• Factory Direct LED Recessed Lighting, Outdoor Wall Lights, Ceiling Fixtures and Electrical Products

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>