Montarbo Active DI-BOX User Manual
- June 5, 2024
- Montarbo
Table of Contents
Montarbo Active DI-BOX
Thank you for purchasing a Montarbo product, the Italian company founded in 1962, and since then serving music and audio. The unique and state of the art Montarbo products are designed with the utmost attention to detail and durability. Reliability is in line with the high quality standards and sensitivity to the environmental impact that distinguish the company.
The MDI-2A active DI-BOX is mainly used on the stage, for optimal management of unbalanced signal from high-impedance instruments such as keyboards, guitar pick-ups and electric basses. A gain reduction PAD [0, -20, -30 dB] and a GROUND to eliminate any ground return hum can be applied to the two balanced output signals, thanks to the internal active circuits. The front connectors are compatible with both classic 6.3 mm TRS jacks and RCA connectors. It is also possible to take repetitions of the input signals through the convenient THRU connectors on the front panel.
PACKAGE CONTENTS
- 1 x Active DI-BOX
- 1 x User Manual – Section 1
- 1 x User Manual – Section 2
WARNINGS
This manual warnings must be complied in conjunction with “User Manual –
section 2”. Please read the manual before using.
Keep this manual handy for future reference.
FRONT CONTROL PANEL
-
LEFT/RIGHT PAD
3-position dimming selector [0 dB -20 dB -30 dB] applicable to LEFT and RIGHT channel. -
LEFT/RIGHT INPUT
Unbalanced signal input on connector:
TRS The relevant electrical connections are: Tip = + “warm” positive
Sleeve = screen or mass
RCA The relevant electrical connections are: Tip = + “warm” positive
Sleeve = screen or mass. -
LEFT/RIGHT THRU
Unbalanced signal output, repetition of LEFT input, on connector
TRS The relevant electrical connections are: Tip = + “warm” positive
Sleeve = screen or mass.
BACK
-
4 RIGHT
Balanced signal output on XLR connector. -
5 GROUND
Press this key (LIFT) to interrupt ground connection between input and output. Use this function to solve ground loops or hums. -
6 BATTERY
Press this key to power the unit with a 9V DC battery. The adjacent LED is steady ON during battery operation. -
7 LEFT
Balanced signal output on XLR connector
BOTTOM
- 8. BATTERY COMPARTMENT
Open the door and insert the 9V DC battery (not included).
NOTE: disconnect the battery from the connection terminals in case of prolonged inactivity.
TECHNICAL SPECIFICATIONS
Type | Active DI-BOX |
---|---|
Channels | 2 |
Input connectors | 6.3 mm jack, RCA |
Maximum input level | +1 3dBu/+4 dBu |
Input impedance | 180kΩ @PAD= 0 dB |
Output connectors | XLR |
Frequency response | 20 Hz-20 kHz |
Total harmonic distortion | <0.002%@1 kHz |
Indicators | Battery |
Controls | ground lift, Battery |
Operating voltage | 9V block |
Dimensions (L x H x D) | 172 mm x 42.5 mm x 112 mm |
Weight | 752 g |
A.E.B. Industriale S.R.L.
Via Brodolini, 8 – Località Crespellano 40053 Valsamoggia – Bologna (ITALIA)
Tel +39 051 969870 –
Fax +39 051 969725 www.montarbo.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>