Ausounds AU-Stream True Wireless Noise Cancelling Earbud User Manual
- June 3, 2024
- AUSOUNDS
Table of Contents
USER MANUAL
AU-Stream True Wireless Noise Cancelling Earbud
Thank you for purchasing the AU-Stream ANC+ True Wireless Earbuds. Please read
this user manual carefully before using this product, and keep it for future
reference.
These true wireless earbuds come with Bluetooth ® 5.1 technology, for easy
seamless connection. We took our time to create a wireless earbud with the
audio that would be respected by the music creator community, but would also
serve the purpose of music lovers everyday use.
CONTENTS
Please check if the following parts in the package are complete
PRODUCT DETAILS
Please charge for 1 hour prior to the first use.
LISTENING COMFORT
Select the right size ear tip
Select the ear tip that provides the most comfortable fit and audio seal.
Lightly pull the ear tip to remove it from the earbuds, and install a new
suitable ear tip.
Wearing earbuds
Lightly insert the earbuds into the ear and rotate it for a comfortable fit. There is a left side and a right side earbud as indicated by the L and R markers on them.
BLUETOOTH FEATURES
Automatic connection
The AU- Stream ANC+ stores your last connected device in memory. If your
earbuds are disconnected due to being out of range, they will automatically
reconnect once in range. If it is disconnected for No more than 5 minutes,
select the Bluetooth name in your device to connect again. If it is
disconnected for more than 7 minutes, it will
automatically shut down.
Automatically switch between left and right ear
Removing either the left or right earbud from the charging case will switch
the mode to single ear state and only play audio through the remaining active
earbud.
Reset
You might need to reset your earbuds if you experience any connectivity
problems or function issues.
- Place the earbuds in the charging case and leave the case open.
- Press and hold the button on the side of the bottom case for 6 seconds until the LED indicators flash red for 4 times .
CHARGING
Battery life
Please charge for 1 hour prior to first use. Allow an additional 15 minutes
once inital charge has been completed. In Bluetooth mode only, a single play
can last up to 6 hours. After noise reduction is enabled, the single play is 5
hours, and the total battery life can reach 25 hours with charging case.
Earbuds
Put the earbuds in the charging case and they will automatically shut down and
enter the charging state.
Charging case
PLAYBACK CONTROLS
Touch Control|
Left Ear
| Right Ear
---|---|---
ANC ON/ANC OFF/Monitor Mode| Long press for 2 sec| Long press for 2 sec
Previous/Next track| Double tap| Double tap
Answer| Tap once| Tap once
Decline call/End call| Long press for 2 sec| Long press 2 sec
Play/Pause| Tap once| Tap once
Activate voice assisstant| Tap 3 times| Tap 3 times
Volume +/- adjustment will be achieved by adjusting the volume of the phone.
SPECIFICATIONS
Bluetooth Version | BT 5.1 |
---|---|
Bluetooth Protocol | HFP1.7,HSP1.2,A2DP1.3,AVRCP1.6,SPP1.2 |
Bluetooth Range | 10m |
ANC Depth | 30db |
Driver Type | Biodynamic driver |
Driver Size | 10mm |
Impedance | 32 ohms |
Frequency Range | 20Hz-20kHz |
SPL | 102db |
Battery Life (total) | 25 Hours |
Battery Capacity (earbud) | 40mAh |
Charging Time | 1.5 Hours |
Weight (earbud) | 4.5g |
Waterproof Level | IPX4 |
SAFETY INSTRUCTIONS
- Do not attempt to make any modifications to the product, including removing or modifying the product, as the damage is not covered by the warranty.
- Do not place the product in extremely high or low ambient temperatures for extended periods of time. Extreme temperatures can cause equipment to deform, and reduce the charging capacity of the device.
- Thunderstorm weather may affect the normal use of the product and there is a risk of electric shock, so please do not use the earphones outside during thunderstorms.
- This product contains small parts. Do not swallow it to avoid danger. Keep the product out of the reach of children.
- Using the product for a long time at high volume may affect your hearing, please control the volume.
- If this product supports active noise cancellation. Please do not turn this function on when walking, driving, or cycling to avoid accidents.
BATTERY WARNING
This product contains lithium battery, please do not disassemble, impact, squeeze or put into fire. Please do not place the product under high temperature or hot sun, beware of explosion. If there is swelling, leakage, odor or any other abnormality in the battery compartment of the product, do not continue to use it. Please dispose of used batteries properly in accordance with local regulations.
WARNING
Do not subject the product to excessive shock. If your product has touch
sensor, do not apply stickers or other adhesive items to the touch sensor
control panel. Be careful not to catch your finger in the unit when folding.
The Bluetooth function may not work with a mobile phone, depending on the
signal conditions and the surrounding environment. Do not apply weight or
pressure to the product for long periods, including when it is stored, as it
may cause deformation. If you experience discomfort while using the product,
stop using it immediately. If this product has earpads/ ear tips they may be
damaged or deteriorate with long-term use and storage.
CLEANING THE UNIT
When the outside of the product is dirty, clean it by wiping with a soft dry
cloth. If the product is particularly dirty, soak a cloth in a dilute solution
of neutral detergent, and
wring it well before wiping. Do not use solvents such as thinner, benzene, or
alcohol, as they may damage the surface.
DO NOT USE THE HEADSET NEAR MEDICAL DEVICES
This product has magnets which may interfere with pacemakers, defibrillators
and programmable shunt valves or other medical devices. Do not put this
product close to
these medical devices and the person who use any of these medical devices.
Consult your doctor before using this product, if you have any concerns.
DO NOT PLACE CARDS WITH MAGNETS IN THE VICINITY OF THE HEADSET
This product has magnets. Placing cards with magnets in the vicinity of the
product may affect the magnetism of the card and render it unusable.
READ ALL INSTRUCTIONS BEFORE USE AND SAVE THESE INSTRUCTIONS FOR FUTURE
REFERENCE
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
FCC RF EXPOSURE STATEMENT: This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter. This device
complies with FCC radiation exposure limits set forth for an uncontrolled
environment.
CAUTION!
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
ISEDC STATEMENT
This device complies with Innovation, Science, and Economic Development Canada
license-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired
operation of the device.
This Class B digital apparatus complies with Canadian ICES-003.
ISEDC RF EXPOSURE STATEMENT
The device is compliance with RF exposure guidelines, users can obtain
Canadian information on RF exposure and compliance.
PRODUCT WARRANTY
Ausounds Intelligence warrants this product to the original purchaser to be
free fromdefects in material and workmanship, under normal conditions for a
period of 1-year for parts and labor only from the date of original purchase.
Ausounds agrees at our option during the warranty period, to repair any defect
in material or workmanship or to furnish an equal product in exchange without
repair charges, during the first 365 days. After 365 days, a flat labor rate
may be required and payment sent along with the product. Except where
prohibited by applicable law, this warranty is nontransferable and is limited
to the original purchaser and the country in which the product was purchased.
This warranty gives you specific legal rights, and you may also have other
rights, including a longer warranty duration that may vary under local laws.
If you do not find a solution on our website, please contact the retailer from
whom you made your purchase. Valid warranty claims are generally processed
through the point-of-purchase retailer during the first thirty (30) days after
purchase. This period of time may vary depending on the retailer. If your
warranty claim cannot be processed through the point-of-purchase retailer,
please contact our support department at
support@ausounds.com or call direct at
1-818-873-0113.
Please follow these directions to return your product:
- Contact Ausounds support at support@ausounds.com or 818-873-0113 to receive a return authorization
- Pack the unit in a well-padded sturdy carton if you do not have the original packaging
- Enclose a copy of your sales receipt to validate the date of purchase
- Ausounds will elect to repair or replace the product free of repair charges during the first 365 days. After 365 days, payment for labor may need to be sent with the
product. Call customer support at 818-873-0113 or email support@ausounds.com
Ausounds Intelligence
Attention: Warranty Services
3190 Chicago Ave Riverside, CA 92507-3448 US
NOTE: This warranty does not cover any product which has been subject to
damage due to misuse, neglect, accidental damage, abuse, commercial use, or
any product modifications. This warranty does not cover damage due to improper
operation or maintenance, connection to an improper voltage supply, or
attempted repair by anyone other than Ausounds. This warranty does not cover
products sold AS IS or refurbished units. For consumers, who are covered by
consumer protection laws or regulations in their country of purchase or, if
different, their country of residence, the benefits conferred by Ausounds’
Limited Warranty are in addition to all rights and remedies driven by such
consumer protection laws and regulations , including but not limited to these
additional rights.
National Statutory Rights
Consumers have legal rights under applicable national legislation governing
the sale of consumer goods. Such rights are not affected by the warranties in
this Limited Warranty. In Brazil, remedies include the consumer’s option to
keep the defective product and receive a proportional price reduction.
European Union Notice: Please note that, in the European Union, any
warranty period less than two years shall be increased to two years.
For Australia/New Zealand Consumers Only:
Our goods come with guarantees that cannot be excluded under the Australian
Consumer Law. You are entitled to a replacement or refund for a major failure
and for compensation for any other reasonably foreseeable loss or damage. You
are also entitled to have the goods repaired or replaced if the goods fail to
be of acceptable quality and the failure does not amount to a major failure.
This warranty is provided by Ausounds Intelligence, LLC 15300 Ventura Blvd
Suite 214 Sherman Oaks, CA 91403. Contact information for Australia/New
Zealand Consumers Only: Telephone: 1
818-873-0113. For any product/warranty
-related questions, please contact customer support at
support@ausounds.com
For Japan Consumers Only: The Federal Arbitration Act (the “FAA”) applies to
the agreement to arbitrate to the maximum extent allowable. Except as
preempted by FAA, the laws of the State of California, without reference to
its choice of laws principles, will govern this Limited Warranty. With the
exception of disputes in small claims court or in arbitration, You and
Ausounds consent to jurisdiction and venue in the state or federal courts
located in Los Angeles County, California, for any claims arising out of a
dispute relating to this Limited Warranty. Notwithstanding the Section titled
“Binding Arbitration and Class Action Waiver”, if You are a consumer in Japan,
You have the right to resolve disputes before the Tokyo District Court in
Japan. Nothing in this Limited Warranty affects Your rights as a consumer in
Japan to rely on mandatory provisions of Japanese law. Contact information for
Japanese Consumers Only: Telephone: 03-3477-0122. For any product/warranty
-related questions, please contact
customer support at support.jp@ausounds.com
Ausounds Intelligence, LLC.
15300 Ventura Blvd., Suite 214
Sherman Oaks, California 91403, USA
www.ausounds.com
Designed by Ausounds in California | Made in China
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>