WATERWARE FWCU8303 Cube Round Shower and Bath Mixer Installation Guide
- June 3, 2024
- WATERWARE
Table of Contents
WATERWARE FWCU8303 Cube Round Shower and Bath Mixer
OVERVIEW
Total adjustment range measured from wall to finished surface is 55mm to 65mm.
INSTALLATION INSTRUCTION
- Mount the Mixer body in place, using screws provided. Ensure the mixer body is level.
- Connect hot and cold water supplies as shown.
- Cut a 75mm diameter hole in the finished wall surface as shown.
- Remove the protective cover, fit the dress plate for the mixer body in place. Fit the handle onto cartridge spindle and fasten grub screw, then put cap on.
Finished work
Notes
- Pressure rating:150-500kpa. If the pressure exceeds or is likely to exceed 550kpa, an approved pressure limiting device must be installed.
- Temperature rating: 1-75°C. If the water temperature exceeds 55°C, an approved tempering valve must be fitted.
- Flush out all pipes prior to installation.
- lnstallalion should comply with Australia standard AS/NZS3500 or relevant local authority requirements.
Maintenance and Care
- AII products should be cleaned with mild detergent or soapy water by using a soft cloth or dampened sponge.
- Dry with a soft cloth after each use and clean regularly.
- Do not use any chemical or abrasive cleaners.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>