WATERWARE FWCU8268 Cube Tall Basin and Vessel Mixer Installation Guide
- June 3, 2024
- WATERWARE
Table of Contents
WATERWAY FWCU8268 Cube Tall Basin and Vessel Mixer
INSTALLATION INSTRUCTION
- Cut a 35mm hole in diameter and ensure there is 60mm circle space for mounting.
- Underneath the Mounting hole, screw down the Lock nut till the end of Mixer tail, feed the Metal washer then Rubber washer from the upside onto the Mixer Tail. Feed hoses through the mixer tail and then both mixer tail& hoses through the hole.
- Feed the dress ring onto the mixer tail, and screw the hoses into the mixer body per the below instruction. Screw the mixer tail into the mixer body, don’t scratch the dress ring while screwing. Place the mixer into position.
- Underneath the mounting hole, firmly fasten the locknut and then tighten the Screws.
- Connect hoses to the water supply. Test and check for leaks.
- Finished work
Notes
- Pressure rathg:150-500kpa. fF the pressure exceeds or Iskely to exceed 550kpa, an approved pressure limiting device must be Installed.
- Temperature rating: 1-75°C. f the water temperature exceeds 55°C, an approved tempering valve must be fitted.
- Flush out al pipes prior to installation. 4nstaladon should comply with Australia standard AS/NZS3500 or relevant local authority requirements.
Maintenance and Care
- All products should be cleaned with a mild detergent or soapy water by using a soft cloth or dampened sponge.
- Dry with a soft cloth after each use and clean regularly.
- Do not use any chemical or abrasive cleaners.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>