BaByliss 2774U Hydro Fusion 4-In-1 Hairdryer Brush User Manual
- June 3, 2024
- BaByliss
Table of Contents
BaByliss 2774U Hydro Fusion 4-In-1 Hairdryer Brush
SAFETY CAUTIONS
- Original instructions. Read these safety precautions carefully before using the unit! This appliance should only be used as described within this instruction booklet. Please retain for future reference.
WARNING! THIS APPLIANCE GETS HOT!
- ALWAYS keep out of reach of children (during and after use and whilst cooling).
- Always take extra care if used on children or near children.
- Do not use it on very young children.
IMPORTANT SAFETY
- UK Only: This appliance must not be used in the bathroom.
- Outside the UK: If using the appliance in a bathroom, unplug it after use as the proximity of water can be dangerous even if the appliance is switched off. For additional protection, the installation of a residual current device (RCD) with a rated residual operating current not exceeding 30mA is advisable in the electrical circuit supplying the bathroom. Ask your installer for advice.
- WARNING! Do not use this appliance near bathtubs, showers, basins or other vessels containing water.
- Do not immerse the appliance into water or other liquids.
- Always inspect the appliance before use for noticeable signs of damage. Do not use if damaged, or if the appliance has been dropped. In the event of damage, discontinue use immediately. Contact the Conair Customer Care Line (refer to ‘UK After Sales Service’ section for further information).
- Do not use the appliance if the lead is damaged. In the event of damage, discontinue use immediately. If the lead is damaged it must be replaced by the manufacturer. Return the appliance to the Customer Care Centre (refer to ‘UK After Sales Service’ section for further information). No repair must be attempted by the consumer.
- Do not leave the appliance unattended when switched on or plugged in.
- This appliance is equipped with a safety thermostat. In the event of overheating the appliance will either stop automatically or run hot and cold intermittently. Should this happen, switch the appliance to the ‘0’ position, unplug and allow to cool for 10 minutes. Before use, ensure the rear filter is clear of hair and other debris. Plug in and switch on. If the appliance continues to overheat discontinue use immediately, switch off and unplug, and contact the Conair Customer Care Line (refer to ‘UK After Sales Service’ section for further information).
- Take care that the air vents do not become blocked when in use. Ensure the rear filter is clear of hair and other debris before use.
- Always ensure that the rear air filter is kept away from hair during use to prevent it being dragged into the fan which may cause the appliance to overheat.
- Take care using this appliance when wearing jewelry, in particular necklaces and earrings to avoid entanglement in the rotating brush head.
- This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand, the hazards involved. Children shall not play with the appliance. Cleaning and maintenance shall not be made by children without supervision.
- Allow the appliance to cool before storing away.
- After use, do not coil the lead around the appliance as this may cause damage to the lead. Instead, coil the lead loosely by the side of the appliance.
- Do not use any accessories other than those recommended by BaByliss.
- Always unplug the appliance when not in use or before cleaning.
- This product complies fully with all appropriate EU and UK Legislation and the Standards relevant to this type and class of appliance. We are an ISO9001:2015 certified company that continually evaluates our Quality Management System performance. If you have any queries regarding product safety and compliance, please contact the Conair Customer Care Line. (See ‘UK After Sales Service’ section for further information).
INSTRUCTIONS FOR USE
- Ensure the hair is 80% dry and combed through to remove any tangles. Divide the hair into sections ready for styling.
- Secure the selected attachment onto the handle. To interchange between the attachments, refer to the ‘Changing the Attachments’ section.
- Slide the switch to the heat setting suitable for your hair type to turn the appliance on. Please note: The blue LED light will illuminate to indicate the ionic feature is activated.
- After use, slide the switch to the ‘0’ position to switch off and unplug the appliance.
- Allow the appliance to cool before storing away.
Changing the Attachments
- Place the attachment onto the handle and line up the two indents with the buttons on the handle.
- Push the attachment onto the handle until it clicks into place.
- To remove an attachment, press and hold the two buttons on the side of the appliance and pull the attachment away from the handle.
Large Oval Volumising & Shaping Brush Attachment
- Place the brush head underneath a section of hair, close to the scalp and hold for a few seconds to boost volume at the roots.
- Use the brush head to lift the hair at the roots as you dry.
- Slowly move the brush head down through the hair, as you reach the end of the hair section, rotate the airstyler slightly towards your face to curl the ends under.
- For a lasting style, select the cool setting ‘*’ on warm hair whilst holding the brush head at the roots.
- Repeat for each section of hair.
Drying Nozzle Attachment
- Use the drying nozzle attachment to remove excess moisture prestyling by directing the airflow onto the hair and moving the airflow around the head.
Straightening Brush Attachment
- Place the brush head under a section of hair, close to the scalp with the firm bristles pointing upwards.
- Use your other hand to pull the hair section taut against the brush head until the firm bristles penetrate through the hair.
- Gently glide the brush head through the section creating tension and control through the hair to straighten the section.
- As the brush head nears the end of the hair section, turn the brush head under to give shape at the ends of the hair.
- For added control, place your other hand over the brush head as you glide down the hair section.
- Repeat for each section of hair.
Smoothing Cushion Brush Attachment
- Place the brush head under a section of hair, close to the scalp with the soft flexible bristles pointing upwards.
- Use your other hand to pull the hair section taut against the brush head until the bristles penetrate through the hair.
- Gently glide the brush head through the section of hair to remove knots and curls and smooth as you dry.
- For added control, place your other hand over the brush head as you glide down the hair section.
- To finish your style and smooth the top of the hair, place the brush on the top of the hair section and brush as normal.
- Repeat for each section of hair.
Heat Settings
There are 2 heat settings plus a cool setting. Use the cool setting on warm
hair to set your style. Slide the switch to the first position to select the
cool setting ‘*’, the second position for the low heat ‘I’, and the third
position for the high heat ‘II’. If you have delicate, fine, bleached or
colored hair, use the lower heat setting. For thicker hair, use the higher
heat setting.
Advanced Plasma Technology with Dual Ionic System
The moisture-balancing dual ionic system combines both positive and negative
ions, that work together to hydrate the hair and to eliminate frizz as you
dry.
CARE & MAINTENANCE
To help keep your appliance in the best possible condition, follow the steps below:
- Ensure the appliance is switched off, unplugged and cool. To clean the outside of the appliance, wipe with a damp cloth. Make sure that no water enters the appliance and it is completely dry before use.
- Do not wrap the lead around the appliance, instead coil the lead loosely by the side of the appliance.
- Do not use the appliance at a stretch from the powerpoint.
- Always unplug after use.
Cleaning the Rear Filter
- Ensure the appliance is switched off, unplugged and cool.
- Using a soft brush, clean any hair and other debris from the filter.
For more information on this appliance visit www.babyliss.co.uk
UK GUARANTEE
This BaByliss appliance is guaranteed for consumer use for 3 years and is only
valid within the United Kingdom.
This guarantee covers consumer use only i.e. defects occurring under normal
use within the home from date of purchase or date of delivery, whichever is
later. If the product develops a fault due to defects in materials or
manufactures within 12 months from the date of purchase, to avoid delays and
unnecessary inconvenience, where possible please return the product to the
point of purchase for an exchange. If the product develops a fault due to
defects in materials or manufacture after 12 months from the date of purchase,
and within the guarantee period, Conair UK After Sales Service will repair or
replace the product.
Exclusions
This guarantee will no longer be valid meaning that The Conair Group Ltd will
not be liable to repair or replace your product where:
- The appliance has been used on a voltage supply other than that which is marked on the product or advised within this instruction booklet
- The appliance has been purchased from an unauthorized stockist*
- The appliance is used for professional/non-domestic usage
- Repairs or alterations have been attempted by unauthorized persons
- The failure of the appliance is a direct result of misuse
- The failure is a result of not following the instructions for use.
This guarantee does not cover any cosmetic damage due to misuse of the product
nor any damage to persons or property that occurs because of product misuse.
unauthorized stockists include, but are not limited to online auction sites,
private sellers and those selling second-hand goods, refurbished products etc.
Please contact the Conair Customer Care Line on 03705 133 191 (09:00 to 17:00
Monday to Friday) or e-mail ukinfo@conair.com for
further information on authorized stockists. It is important to retain your
proof of purchase. We recommend attaching your receipt to this page. Even
where a refund may be applicable, no refund will be provided without a valid
receipt or proof of purchase, we will only be able to offer a repair or
replacement service. Please note this does not apply if the product was
purchased directly from The Conair Group Ltd. Guarantees on replacement
products run from the original purchase date or date of delivery, whichever is
later, and not from the date of replacement.
This guarantee is an additional benefit and does not affect your statutory
rights as a consumer.
If you have any queries regarding this guarantee please contact the Conair
Customer Care Line on 03705 133 191 (09:00 to 17:00 Monday to Friday) or
e-mail ukinfo@conair.com
UK AFTER SALES SERVICE
For further advice on using the appliance or should you need to return your product, please contact the Conair Customer Care Line on 03705 133 191 (09:00 to 17:00 Monday to Friday) or e-mail your inquiry to ukinfo@conair.com.
Return address:
Customer Care Centre
Conair Logistics
Unit 4, Revolution Park
Buckshaw Avenue
Buckshaw Village
Chorley
PR7 7DW
Please enclose your return number, name and address details, together with a copy of proof of purchase and details of the fault. Please note this Instruction Booklet is not guaranteed.
SAFE DISPOSAL
The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead, it should be handed to an appropriate collection point for the recycling of Electrical and Electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about the recycling of this product, please contact your local council office or your household waste disposal service.