SURFACE MAXX SGY-PWA83A Pressure Washer Foam Cannon Instruction Manual

: June 3, 2024
: Surface Maxx

Table of Contents

SURFACE MAXX SGY-PWA83A Pressure Washer Foam Cannon
Instruction
ASSEMBLY INSTRUCTIONS
OPERATING INSTRUCTIONS
CARE AND MAINTENANCE
TROUBLESHOOTING
Warranty
Read User Manual Online (PDF format)
Download This Manual (PDF format)

SURFACE MAXX SGY-PWA83A Pressure Washer Foam Cannon

Instruction

With the sprayer removed from the bottle, fill bottle with warm water and soap made for foam cannons (not included). Use recommended water to soap ratio on the soap label.

ASSEMBLY INSTRUCTIONS

Attach bottle to sprayer. Turn sprayer “clockwise” until tight. Do not overtighten .
Connect foam cannon to quick connect fitting on you spray gun or wand.
Note: Pressure washer should be off during Connection or trigger in locked position.

OPERATING INSTRUCTIONS

The air intake knob adjusts the amount of foam, turn counterclockwise for more foam and turn clockwise for less foam .
With the pressure washer on, pull the trigger on pressure washer gun to spray foam.
Note: Do a test shot away from the object you are
praying to ensure the foam cannon is attached properly and you are getting the spray pattern you want.
CAUTION: Do not point foam cannon at people or animals as it can cause injury.
When finished, shut off pressure washer. Relieve any pressure left in the line by pulling trigger on pressure
washer gun. Remove the foam cannon from the quick connect fitting .
Remove the sprayer from the bottle. Turn sprayer “counterclockwise” until you can remove it from the bottle .
Empty any remaining soap mixture.

CARE AND MAINTENANCE

To clean foam cannon, take the sprayer (without the bottle) and hook it back up to pressure washer gun or wand. Place intake tube into a bucket of clean water. Turn on pressure washer and run clean water through the sprayer.
When done, turn off pressure washer, disconnect sprayer and dry.

TROUBLESHOOTING

Problem	Possible Cause	CORRECTIVE ACTION
Connections leak.	1. Inlet plug loose.
2. Bad coupler.	1. Retighten fittings.

2. Replace coupler.
Low soap output.| 1. Too little soap added.
2. Filter is clogged.| 1. Check manufactures recommended.
2. Try cleaning the filter.
3. Replace the filter.

Warranty

Two YEARS LIMITED WARRANTY
he manufacturer warrants this product against defects in materials and workmanship for two (2) years from date of purchase. If within this period a product is found to be defective in material or workmanship, the product must be returned with a copy of the bill of sale as proof of purchase to the manufacturer. This warranty does not cover the product becoming defective due to misuse, accidental damage, improper handing and/or installation and specifically excludes liability for direct, incidental or consequential damages. As some states d not allow exclusions or limitations on how long an implied warranty lasts, the above exclusions and limitations may not apply to you. This warranty gives you specific rights and you may also have other rights which vary rom state to state. For warranty service, call +1 866-870-9930, 9 a.m. – 5 p.m., EST, Monday – Friday.