Surface Maxx SGY-PWA97 14 Inch Water Broom and Undercarrige Cleaner Instructions
- June 9, 2024
- Surface Maxx
Table of Contents
ITEM #2637679
INSTRUCTION SHEET
14″ Water Broom & Undercarriage Cleaner
MODEL #SGY-PWA97
SGY-PWA97 14 Inch Water Broom and Undercarrige Cleaner
PACKAGE CONTENTS
| PART | DESCRIPTION | QUANTITY |
|---|---|---|
| A | 14″ Water Broom & Undercarriage Cleaner | 1 |
PRODUCT SPECIFICATIONS
| COMPONENT | SPECIFICATIONS |
|---|
Connections
Broom Width
Maximum Pressure
Maximum Water Flow
Maximum Water Temperature
Weight| 1/4 in. Quick Connect Plug
14 in.
3,300 PSI
3 GPM
140°F (60°C)
2.1 lbs.
IMPORTANT SAFETY INSTRUCTIONS
DANGER:
To reduce the risk of injury, the user must read and understand this insert
sheet as well as the operator’s manual for their pressure washer before using
this product. Failure to follow all warnings and precautions may result in
death, serious personal injury, or property damage.
WARNING:
- Observe the safety instructions of your pressure washer.
- The product must not be used by children.
- Keep all persons/animals clear of the immediate vicinity of the cleaning head.
- Keep hands away from moving parts.
- Turn off the pressure washer and relieve the pressure when examining or changing the product and after the completion of the cleaning operation.
- The product is not suited for scouring or scrubbing.
- Do not run over freestanding corners.
- Wear eye protection with side shields marked to comply with ANSI Z87.1.
- Test the product in an inconspicuous area.
- Not to be used on vertical surfaces.
- Do not exceed the maximum rated pressure, volume, or temperature listed in the product specifications.
ASSEMBLY INSTRUCTIONS
- Attach the cleaner’s 1/4 in. quick connect plug into the end of the pressure washer wand.
- Connect hose to the pressure washer and start pressure washer as described in its Owner’s Manual.
- Pull the pivot knob out and move the pivot coupler back or forward to achieve the desired nozzle orientation.
CAUTION: Risk of injury can occur if the cleaner’s 1/4 in. quick connect plug is not properly inserted into the quick connect coupler. Make sure you hear a “click” sound when attaching the 1/4 in. quick connect plug to the quick connect coupler.
OPERATING INSTRUCTIONS
- Use with the nozzles pointed down and forward (pivot coupler in back position) to wash large flat surfaces like sidewalks or driveways. Walk slowly behind the cleaner, cleaning as you go.
WARNING: To reduce the risk of injection or injury, never lift the cleaner while operating the pressure washer. - Rotate the spray bar 180° so the nozzles are pointed upward (make sure the pivot coupler is in the forward position) to clean the underside of raised items like your car’s undercarriage.
WARNING: To reduce the risk of injection or injury, do not depress the trigger until the cleaner nozzles are completely underneath the surface being cleaned, and always release the trigger before removing the cleaner from underneath the surface.
MAINTENANCE
A clogged or dirty nozzle will result in excessive pump pressure causing a pulsing sensation.
-
Turn off the pressure washer and turn off the water supply. Release the residual pressure by squeezing the gun’s trigger.
-
Disconnect the pressure washer wand from the cleaner.
-
Remove the inlet plug filter and clean with running water. (See Figure 1)
-
Using a wrench (not provided) remove the nozzle from the spray bar.
-
Using a straightened paper clip, free any foreign material clogging or restricting the nozzle. (See Figure 2)
-
Flush debris out of the nozzle. Direct the flow of water through the nozzle backwards from the outside to the inside.
-
Attach the wand back to the cleaner, set the cleaner on a flat surface.
Turn on the water (DO NOT START THE PRESSURE WASHER) and squeeze the trigger on the gun.
Allow water to run through the spray bar for approximately 30 seconds. -
Reinstall the nozzle to the spray bar. Tighten securely. Align the nozzle opening as shown in Figure 3.
Note: After tightening securely, nozzle opening should be pointed in same direction as spray bar.
Note: If your spray pattern begins to change, it could mean that the nozzles are worn and they will need to be replaced.
WARRANTY
TWO YEARS LIMITED WARRANTY
The manufacturer warrants this product against defects in materials and
workmanship for two (2) years from date of purchase. If within this period a
product is found to be defective in material or workmanship, the product must
be returned with a copy of the bill of sale as proof of purchase to the
manufacturer. This warranty does not cover the product becoming defective due
to misuse, accidental damage, improper handing and/or installation and
specifically excludes liability for direct, incidental or consequential
damages. As some states do not allow exclusions or limitations on how long an
implied warranty lasts, the above exclusions and limitations may not apply to
you. This warranty gives you specific rights and you may also have other
rights which vary from state to state. For warranty service, call +1
866-870-9930, 9 a.m. – 5 p.m., EST,
Monday – Friday.
ATTACH YOUR RECEIPT HERE
Purchase Date ………………………………
Questions, problems, missing parts?
Before returning to your retailer, call our customer service department
at
+1866-870-9930, 9 a.m. – 5 p.m.,
EST, Monday – Friday.
www.surfacemaxx.com
Printed in China
Documents / Resources
|
Surface Maxx SGY-PWA97 14 Inch Water Broom and Undercarrige
Cleaner
[pdf] Instructions
SGY-PWA97 14 Inch Water Broom and Undercarrige Cleaner, SGY-PWA97, 14 Inch
Water Broom and Undercarrige Cleaner, Broom and Undercarrige Cleaner,
Undercarrige Cleaner
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>