SPEKTRUM iX14 14-Channel DSMX Transmitter Instructions

Table of Contents

SPEKTRUM-iX14-14-Channel-DSMX-Transmitter-Product

Product Specifications

Powering On the iX14
To power on the iX14, press and hold the power button until the screen lights up.
Navigating the Interface
Use the touchscreen display to navigate through different menus and options. Swipe left or right to access different features.
Setting Up Models
To set up a new model, go to the settings menu and select “Add New Model.” Follow the on-screen instructions to configure your model settings.
Binding Receivers
To bind a receiver to the iX14, go to the Bind menu and follow the binding instructions provided by your receiver’s manufacturer.
Firmware Updates
Regularly check for firmware updates by going to the System Settings menu and selecting “Check for Updates.” Follow the prompts to update to the latest version.

Frequently Asked Questions (FAQ)

Q: How do I reset the iX14 to factory settings?
A: To reset the iX14 to factory settings, go to System Settings > Reset > Factory Reset. Note that this will erase all your current settings and models.
Q: Can I use the iX14 with other receiver brands?
A: The iX14 is optimized for use with Spektrum receivers, but it may be compatible with other brands. Refer to the product manual for more compatibility information.

Corrections & Improvements

Support new PowerSafe features which utilize AS6000
Support new PowerSafe “fast boot” alarm generation
Support in Sleep Mode screen for putting new PowerSafe receivers into sleep mode
Support Smart Battery data from new PowerSafe receivers
Added Servo Cycler as the new default Sequencer
Added the ability to adjust the output values associated with the positions of Logical Switches

Fixed rare crash when entering RX Port Assignment screen
Fixed rare crash in the Sequencer screen
Corrected issue on Servo Travel screen when values are locked
Corrected behaviour on the Servo Travel screen when servos are reversed
Updated default values for Flight log warnings
Corrected behaviour with TIMER_MIN macros that were not accounting for translations

Taileron differential is now properly mixed to control surfaces
Trim values are now processed properly when switching between flight modes for Aileron wing types
Updated regulatory screens
Turbine status messages are now properly displayed
The dashboard screen properly orders telemetry screens to be displayed when gaps exist in the telemetry configurations
German translation improvements
Airware no longer crashes on the Motor Curve screen when motor input is invalid
Smart Battery telemetry now handles 0 Cycle data correctly
“No Data” in ESC telemetry is now handled properly

The quick sleep button on the Sleep Mode screen has been changed from a press-and-hold to a swipe motion

The system no longer shuts down when coming out of sleep mode
While occurring rarely, corrupted models no longer occur when coming out of sleep mode
Analog trim range now functions correctly with a 30% max trim value when the step size set to one
Turbine EGT is now available as an option on gauge and dashboard pages
Sleep Mode dialog correctly shows the state of the Serial Port Power
Accurate values are displayed on the Flight Log telemetry screen when %Range is selected
Programmable Mixes are now shown in the Digital Switch Setup screen when a switch is assigned as a source
Values are now saved on the Heli Cyclic/Thro Mixing screen
Mixing screen operation has been updated to be more intuitive

Version 1.00.03
Initial Release