ALTA BLISS Automation Serial Bridge User Guide
- June 3, 2024
- ALTA
Table of Contents
ALTA BLISS Automation Serial Bridge User Guide
Product Certification
BLISS Bridge allows the wet to ‘ins their motorized Shades and Blinds into a
SVI.F1 newer* enabling control We Wart APP and interaction with other loT
products and Third Party Integration.
Download the App
STEP 1
Please scan the QR Code below to download the app
STEP 2
Please scan the QR Code below to view more about setting up the BLISS APP
along with additional BLISS Automation troubleshooting and how to videos.
BUTTON AND PORT LOCATION
BLISS Serial Bridge
Programming / Pairing
Press and hold programming button for about 2 seconds, then release until the
LED blinks purple.
Reset
Press and hold programming button for about 10 seconds, then release until the
LED blinks red.
PRODUCT SPECIFICATION
| Input Voltage | 5V DC (USB Type A) |
|---|---|
| Input Power | 1000mA |
| WiFi Network | 2.4Ghz only (802.1 1b/n/g) |
| Shade Control Frequency | 433.92 Mhz |
| Range | 30 meters or 98 feet |
| Protection Class | IP20 |
| Operation Temperature | 32°F to 104°F (0°C to 40°C) |
| Integration | RS485 (Optional) |
STATUS INDICATOR
Color
Constant Blue
Slow Flashing Red
Slow Flashing Yellow
Quick Flashing Red
Slow Flashing Purple
Slow Flashing Green
Meaning
Working fine
Wi-Fi is disconnected
Wi-Fi is connected
Bridge reset
Pairing underway
Upgrade in progress
Duration
Constant
Continuously till status change
Continuously till status change
5 times
Continuously till status change
Continuously till status change
THIRD PARTY INTEGRATION
Additional 3rd party integration programs available.
DECLARATIONS
U.S. Radio Frequency FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
ISED RSS Warning:
This device complies with Innovation, Science and Economic Development Canada
licence-exempt RSS standard(s). Operation is subject to the following two
conditions:
- this device may not cause interference, and
- this device must accept any interference, including interference that may cause undesired operation of the device.
RP exposure statement
This equipment complies with the FCC RF radiation exposure limits set forth
for an uncontrolled environment. This equipment should be installed and
operated with a minimum distance of 20cm between the radiator and any part of
your body. This equipment meets the exemption from the routine evaluation
limits in section 2.5 of RSS-102. It should be installed and operated with a
minimum distance of 20cm between the radiator and any part of your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>