ALTA Honeycomb Shades Instruction Manual

June 4, 2024
ALTA

ALTA Honeycomb Shades

ALTA Honeycomb Shades product

INSTALLATION INSTRUCTIONS

Important: Make sure the mounting surface is level. Brackets must be in line and level for shade to install properly.ALTA Honeycomb Shades fig
1

Inside Mount: Install the brackets level and aligned to each other, using the screws provided. The minimum mounting depth for an inside shallow mount is 3/4”. A minimum of 2” is needed to fully recess a shade with the standard rail. A minimum of 2 1/2” is needed to fully recess a shade with the large rail.
Outside Mount : Center the shade over the window opening at the desired height and mark the end of the shade. The minimum mounting height for outside mounted shades is 3/4”. ALTA Honeycomb Shades fig 1

Spacer Blocks : Each spacer block projects brackets 3/8” away (max 3 sets). Make sure that the brackets are level and aligned. Attach using two screws. Screws should be long enough to secure the bracket to the mounting surface.

Extension Brackets: Extension brackets project the shading up to 2 7/8” from the mounting surface. Attach the mounting bracket to the extension bracket with the nuts and bolts provided.

2a. Install the Shade

2b. Remove the Shade (Only if necessary)ALTA Honeycomb Shades fig
3

Install the Hold-Down Brackets (Optional – OM Only)

ALTA Honeycomb
Shades fig 4

Important: The bottom rail must be disconnected from the hold-down brackets to raise the shade.
First, lower the shade and place the hold-down pins into the hole on the bottom rail end caps. Then, mark the hold-down bracket locations on the mounting surface. Center the hold-down brackets over the mounting hold locations and check their alignment. Finally, attach the brackets using screws.

Adjust the Shade

ALTA Honeycomb Shades fig 5

BOTTOM RAIL SHADE ADJUSTMENT First, lift bottomrail on the side to be adjusted. Then, use a screwdriver or dime.

  • Turn the screw clockwise to lift that side of the shade.
  • Turn the screw counterclockwise to lower that side of the shade.
  • Half a revolution is 1/4” adjustment (the maximum adjustment is 1/2”).

Child Safety

WARNING

STRANGULATION HAZARD – Young chidren can be strangled by cords.
Immediately remove this product if a cord longer than 22 cm or a loop exceeding 44 cm around becomes accessible. Rev 7/21 Print 7/21

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals