SCANCOOL SC 51 BE 1 Door Beverage Cooler User Manual
- June 3, 2024
- SCANCOOL
Table of Contents
SCANCOOL SC 51 BE 1 Door Beverage Cooler User Manual
SAFETY PRECAUTIONS
- To ensure proper use, please thoroughly study these SAFEY PRECAUTIONS before operating the Unit.
- The purpose of the safety precautions in this manual is to ensure safe and correct use of the unit to minimize risks that could cause serious damage and injury to you or other persons. The safety precautions are divided into WARNINGS and CAUTIONS. Cases where improper handing of the unit could lead to death or serious injury are listed under the ‘WARNING” heading. However, the cases listed under the,1,.CAUTION” heading could also lead to serious results. To ensure the safety, adhere strictly to both types of safety precautions.
- Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance.
- Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.
- Do not damage the refrigerant circuit.
- This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
- If the supply cord is damaged, ii must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
- Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
- When disposing of the appliance, do so only at an authorized waste disposal centre. Do not expose to flame.
- Warning: The lamp must not be replaced by the user! If the lamp is damaged, contact the customer helpline for assistance.
- The A-weighted emission sound pressure level is below 70 dB(A)
- The appliance shall be disconnected from its power source during cleaning or maintenance and when replacing parts.
⚠ WARNING Improper handling of the unit could lead to death or serious injury.
⚠ CAUTION Improper handling of the unit could lead lo serious results depending on the circumstances.
- Text set off by the exclamation mark O contains information that should be strictly adhered to.
- After reading the instruction manual, store it an easily accessible place where the user(s) of this product can easily find it.
♦ PRECAUTIONS FOR INSTALLATION
⚠ WARNING
Installation should be performed only by the dealer or a qualified expert.
Attempting to install the unit yourself could result in water leakage,
refrigerant leakage, electrical shock, or fire.
♦ PRECAUTIONS FOR USE
HOW TO USE
BEFORE USE
- Remove shipping package, tape, etc, and leave doors open. Ventilate for a while.
- The unit is cleaned before shipment. However, clean the compartment interior after delivery.
- Please insert power supply plug into the wall outlet ,single-phase to correct voltage.
- Allow the unit to operate for about l hour to cool the compartment before placing items in the cooler.
WAIT 5 MINUTES OR MORE BEFORE RE-STARTING
- Restarting the unit immediately after ii has been turned off may cause fuses to blow and activate the circuit-breaker, the compressor may be overloaded, and/or other damage may occur.
TEMPERATURE ADJUSTMENT
For the display cooler, the interior temperature will be kepi at 0-10° Cat a
thermostat temperature selling of 4-5. If the ambient temperature is extremely
high or there are a lot of contents inside the cooler, then the temperature
may rise. Therefore, the thermostat selling would need to be increased.
If the ambient temperature is very low or there is very few contents in the
cooler, then the thermostat selling can be reduced to prevent the internal
temperature going below 0° C. Very low temperatures inside the cooler may
cause the evaporator to ice up.
DRAIN TRAY
- Defrosting is performed automatically and drain water is collected in the drain tray.
- Water in the drain tray is evaporated automatically. In humid environments, there will be a large amount of water in the drain tray, so please throw away drain water once a day.
EFFICIENT USE
- To prevent cold air from escaping, open and close the door quickly and keep the door opened for as short a time as possible.
- Please install the unit in a place which is well-ventilated.
SHELF HEIGHT ADJUSTMENT
The shelf height can be adjusted.
Arrange the shelves in accordance with the dimensions of the items to be
placed in the cooler.
PLACING ITEMS IN THE SHOWCASE
This showcase employs a forced circulation of cold air system. If circulation of cold air is obstructed, the items will not be adequately refrigerated. Pay attention to the following points:
- Do not let items obstruct the cold air inlet and suction outlet.
- Place items so that they do not protrude from the shelves. The gap between the shelves and the door is used for circulation of cold air.
- Place items evenly on all shelves.
CLIMATE CLASS
- 32°C±2°C on appliances of climatic class 0, 1,2,3,4,6 or 8
- 43°C±2°C on appliances of climatic class 5 or 7
CLEANING
⚠ WARNING
To prevent any electrical shock hazards or injury by rotating circulation fan,
always disconnect the power cord plug from the wall outlet before cleaning.
l EXTERIOR AND COOLER COMPARTMENT
Wipe with a soft, dry cloth. If very soiled, wipe with a cloth that has been moistened with a detergent Then wipe with a cloth that has been dipped in water.
⚠ WARNING
WARNING: Do not splash water directly onto the cooler and do not wash with
water. Short -circuit and electrical shock could result.
- Clean the cooler regularly to keep it clean at all times.
- Never use polishing powder. soap powder. benzine. oil or hot water as these will damage the painting and plastic components.
2 CHECKS
To ensure the safety, perform the following checks after cleaning.
- is the power cord plug firmly inserted into a dedicated wall outlet? Confirm that the plug is not abnormally hot.
- check the power cord for cracks and damage. Should the slightest irregularity be observed, contact the dealer from whom you purchased this unit or our customer’s service.
IN CASE OF THE FOLLOWING
-
POWER FAILURE
Keep opening and closing of the door to a minimum.
Avoid placing new items in the cooler as this will raise the temperature inside the compartment. -
WHEN NOT USED FOR A LONG PERIOD
Remove all items from the compartment and disconnect the power cord plug from the wall outlet.
Clean the compartment interior and wipe away all water.
To prevent mold formation and bad smell, leave the door open to dry the compartment completely. -
TRANSPORTATION
Disconnect the power cord plug from the wall outlet.
When moving the cooler, make sure that the feet do not damage the power cord.
Do not let the feet hit against floor steps, thresholds, etc. -
TEMPORARY STORAGE
Affix a piece of wood, etc. Between the door and main unit to prevent complete closing of the door.
Make sure not to store the unused cooler at a location where children play.
Should a child enter the compartment and the door is closed, the child may not be able to open the door from the inside.
BEFORE REQUESTING SERVICE
Please check the following items if you encounter problems with the unit. If the problem continues after taking the proper remedial actions, disconnect the power cord plug from the wall outlet. Transfer the items stored in the cooler to a box or other container. Then contact the dealer from whom you purchased this unit and be ready to provide information as listed in “REQUIRED INFORMATION” below.
⚠ CAUTION
To prevent any electrical shock hazards, do not disconnect the power cord plug
from the wall outlet with wet hands.
Light source in this product is replaceable only by a professional.
Showcase sometimes stop running when thermostat turns off.
REQUIRED INFORMATION
-
Nature of malfunction (as accurately as possible)
-
Product number
ON RATING LABEL
ON CARTON -
Serial number
-
Customer’s name, address, phone number
-
Year and date of purchase
Access to professional repair, such as internet webpages, addresses, contact
details. Model no: SC 21 BE
Aftersales service station list:
Note: The address or contact phone number of the service site is subject to change without prior notice. Please confirm whether the service station is a directly affiliated one of our company when requiring services.
Access to professional repair, such as internet webpages, addresses, contact
details. Model no: SC 51 BE
Aftersales service station list:
Access to professional repair, such as internet webpages, addresses, contact
details. Model no: SC 81 BE
Aftersales service station list:
Note: The address or contact phone number of the service site is subject to change without prior notice. Please confirm whether the service station is a directly affiliated one of our company when requiring services.
EU DECLARATION OF CONFORMITY
Ref. Ares In accordance with EN ISO 17050-1:2004
