SCANCOOL DKS62 Glass Door Cooler Instructions

BEVERAGE COOLER
INSTRUCTIONS
Model: DKS 62

Refrigerator
Thank you for buying this Refrigerator. It has been designed and manufactured for many years of trouble-free service. The operation is very simple, but please take a few minutes to read this booklet. It contains important safety information, and tips to ensure you receive the best possible service from your Refrigerator. This appliance is intended to be used exclusively for the storage of beverages.
WARNING: RISK OF ELECTRICAL SHOCK HAZARD
USERS IN EUROPE This unit must be earthed and plugged into a grounded 220V AC circuit. If the power cable is damaged, it must be replaced by a qualified engineer to avoid shock hazards.DO NOT ATTEMPT TO REPAIR THE ITEM YOURSELF. Ensure that the appliance is properly grounded. Stop using the appliance immediately if an electric shock is felt when touching the cooler.
DISPOSAL OF OLD REFRIGERATORS
BE SURE TO MAKE ANY LOCKS UNUSABLE. IF POSSIBLE, REMOVE THE DOOR(S) AND DISCARD THEM SEPARATELY. WARNING ­ CHEMICAL HAZARD: DO NOT ALLOW CHILDREN TO PLAY WITH THE OLD APPLIANCE. CONTACT YOUR LOCAL AUTHORITY FOR PROPER DISPOSAL PROCEDURES. Before disposing of an old appliance, please make sure it is switched off and safe. Unplug the appliance and break any locks in order to avoid children becoming trapped.
** Please note: the cooling system contains flammable gases and refrigerants which require specialist waste disposal. The materials contained in a refrigerator must be recycled. Contact your local waste disposal depot for proper disposal of an old appliance and contact your local authority or dealer if you have any questions. Please ensure the pipework of your cooler is not damaged prior to disposal.
DISPOSAL OF PACKAGING**
All the packaging materials with your Refrigerator may be disposed of without danger to the environment. The cardboard may be broken or cut into smaller pieces and given to a waste paper disposal service. The wrapping is made of polyethylene. The polyethylene pads and stuffing contain no fluoro chloric hydrocarbons. All these valuable materials should be taken to a waste collecting depot and used again after adequate recycling. Consult your local authority for the name and address of the waste paper disposal services nearest to you.

SAFETY INSTRUCTION & WARNINGS

Before switching on your Refrigerator, read the information in this User Guide carefully. The User Guide contains important observations relating to the assembly, operation, and maintenance of the appliance. Please keep this booklet in a safe place for future reference. If you ever sell this unit, hand this User Guide to the new owner. The manufacturer does not accept responsibility for any damages that may arise due to the non-observation of these instructions.

• Do not use damaged appliances. If you are in any doubt, consult the supplier.
• Connection and installation of the unit is to be carried out in strict compliance with the relevant instructions in this User Guide.
•  For safety, the appliance must be properly earthed in accordance with the specifications.
• Always remember to unplug the appliance before cleaning. Never unplug your cooler by pulling on the power cable. Always grip the plug firmly and pull straight out from the socket.
• All electrical repairs must be carried out by qualified engineers. Inadequate repairs may be dangerous.
• Do not damage any parts of the appliance which carry refrigerant by piercing, perforating, crushing, twisting or scraping. If the refrigerant comes into contact with the eyes, it may cause serious eye injury.
• Do not obstruct or cover the ventilation aperture.
• Do not allow children to play with your Refrigerator, or to sit on it, or swing from the door.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.

SPECIFICATIONS

• This appliance is designed as a beverage cooler.
• It is intended strictly for domestic use.
• The refrigerating circuit is leak-proof.

BEFORE USING IT FOR THE FIRST TIME

• The appliance may be placed with its rear panel directly against the wall. The minimum air gap must be 2 centimeters. For good circulation, the vent at the back of the unit must not be blocked. Your Refrigerator should be placed on a flat and firm surface for quieter operation.
• Do not expose the appliance to direct sunlight or a heat source such as ovens, radiators, heaters, etc.
• Do not under any circumstances place heated beverages in your Refrigerator.
• Do not open the door more often than necessary to lessen the escape of cold air.
• For better air circulation, do not overfill the unit.
• Adjust the temperature regulator according to the amount of product and the ambient temperature.

Turing it to the maximum will cause it to run continuously and ice up.
Avoid the maximum setting.

BASIC OPERATION

Your Refrigerator must stand on an even surface. If the appliance is to be placed on carpet, support it with a wooden board underneath. Be aware that placing the appliance on the carpet may mean that heat from the compressor may cause the carpet to fade.

To operate

1. Plug in your Refrigerator.
2. The first time you turn the unit on, turn the thermostat, situated at the back of the unit, clockwise to the max. position “SUPER”. It can make your Refrigerator cool faster.
3. After 20 minutes, adjust the temperature control setting to “NORMAL”. This setting should be correct for home or office use.
4. To turn the unit off, disconnect the plug from the main supply.

NOTE: If the unit is unplugged or power loss, you must wait for 3 to 5 minutes before restarting. If you attempt to restart the unit before this delay, the unit will not start.
WARNING
If the temperature selector is set to too low a setting, drinks may become frozen. In extreme circumstances, glass bottles may even break. Always exercise caution when setting the temperature.

• Do not place heavy items (more than 20kg/44lbs) on top of the cooler.
• Do not place any items on top of the cooler which may fall off when the door is opened.
• After the appliance has been unplugged, leave for three minutes before plugging it in again.

When not in use
If the unit is not being used for long periods:

• Unplug your Refrigerator.
• Clean and dry the inside of the appliance. Leave the door slightly open to allow it to dry completely
• A cooler that is unused without being cleaned may start to smell musty or develop mildew.

DEFROSTING

The surface of the evaporator ices up when the refrigerator is working. This is an entirely normal part of the operation. If the frost layer is more than 3mm /1/8″ thick, the cooler must be defrosted and cleaned to avoid unnecessary energy consumption and inefficient operation.

1. Remove all items inside and unplug the unit.
2. After defrosting, clean the unit (see instructions below) and allow it to dry. Reconnect to the mains supply with the temperature control at “MAX “, then follow the directions To operate’ andTips for refrigeration’ opposite).

Cleaning

1. Unplug your Refrigerator.
2. Sponge the interior with warm water and neutral detergent.
3. Dry all surfaces thoroughly.

Note: Do not use abrasive cleaners! Do not use sharp objects! To ensure efficient operation the back and bottom of the cooler should be cleaned thoroughly. Use mild soapy water to clean the door seal.
Moving your Refrigerator

• Unplug the appliance
• Remove all items inside

Note: Never hold the appliance by the door. Keep level and upright.
Power Failure

• If a power cut occurs, do not open the door more often than necessary in order to conserve cold air.

TROUBLESHOOTING

Before returning your Refrigerator to the store, check the following points; you may be able to solve any problem yourself.

• Check the power cable is connected and the fuse is intact.

• The wrong temperature was selected. Adjust settings on the controller
  to position shown (see page 3)

• The cooler is overfilled.

• The appliance is exposed to direct sunlight or a heat source.

• The door is opened too often.

• The frost layer is too thick.
  Needs to be defrosted (see page 4).

Unusual noises or noisy operation|

• The appliance is not on a level, firm surface, or maybe touching other items.
• Note: It is normal to hear refrigerant flowing as the compressor stops and starts.

Outer surfaces are wet|

• Water source or leak too near the appliance ­ dry surfaces thoroughly and move the appliance.

Inner surfaces are wet|

• The door is opened too often or kept open too often.

UK
Access to professional repairs, such as internet webpages, addresses, contact details.
Model no: DKS 62
Aftersales service station list:

Relevant information for ordering spare parts, directly or through other channels provided by the manufacturer, importer, or authorized representative;| Scandomestic A/S
The minimum period during which spare parts, necessary for the repair of the appliance, are available;| 8 years
Instruction on how to find the model information in the product database, as defined in Regulation (EU) 2019/2024 by means of a weblink that links to the model information as stored in the product database or a link to the product database and information on how to find the model identifier on the product.)| www.scandomestic.dk

Note: The address or contact phone number of the service site is subject to change without prior notice. Please confirm whether the service station is a directly affiliated one of our company when requiring services.

EU DECLARATION OF CONFORMITY
Ref. Ares In accordance with EN ISO 17050-1:2004

Scandomestic A/S Unavej 20
8600 Silkeborg
Denmark
This declaration of conformity is issued under the sole responsibility of the manufacturer (or installer):| Scandomestic A/S Unavej 20
8600 Silkeborg
Denmark
The object of the declaration (identification of product allowing traceability. It may include a color image of sufficient clarity to enable the identification of the product, where appropriate.)
Product: Display Cooler Brand: Scancool
Colour: White
Model name: DKS 62|
The object of the declaration described in point 4 is in conformity with the relevant Union harmonization legislation:| EN 61000-3-2
References to the relevant harmonised standards used, or references to the specifications in relation to which conformity is declared:| EN ISO 12100:2010, EN 60335-1:2012/A11:2014, EN60335-2-89:2010/A1:2016, EN62233:2008, EN55014-1:2006/A2:2011, EN55014- 2:1997/A2:2008, EN 61000-3-2:2014, EN 610003-3:2013, IEC 60335-2 89:2010+A1:2012, 1EC60335-1:;2010+A1:2013
Where applicable: the notified body … (name, number)… performed … (description of intervention)… and issued the certificate:| RoHS
Additional information:| Commercial Cooler

Scandomestic A/S
Silkeborg, d. 16/04/2021
Anja Hømlund
Product Manager

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>