FORGING MOUNT HY4107 Wooden Base Universal TV Stand Instruction Manual
- June 3, 2024
- FORGING MOUNT
Table of Contents
****
FORGING MOUNT HY4107 Wooden Base Universal TV Stand
Safety Caution
UNPACKING INSTRUCTIONS
- Carefully open the carton, remove contents and lay out on cardbard or other protective surface to avoid damage.
- Check to assure that all components were received undamaged. Do not use damaged or defective parts. lf you require replacement parts, contact customer service at forgingmount888@163.com
- Carefully read all instructions before attempting installation.
IMPORTANT SAFETY INFORMATION
- Install and operate this product with care. Please read this instruction before beginning the installation, and carefully follow all instructions contained herein. Use proper tools during installation.
- If you do not understand the instructions or have any concerns or questions, please contact customer service at forgingmount888@163.com
WARNING:
Exceeding the weight capacity can result in serious personal injury or
damage to equipment!
It is the installer’s responsibility to make sure the combined weight of
HY4107 and the display does not exceed 99 ibs(45kg).Use with heavier
televisions may result in instability causing tip
over resulting in death or serious injury!
This product contains small items that could be a choking hazard if swallowed.
Keep these items away from young children
Supplied parts
Assemble the TV Stand
Place foot pads (Q)on the bottom of the wooden base at the corners Attach
the Support Pillar to the W ooden Base
Attach the TV Plate to Support Pillar 
Mounting the TV Brackets(04) to your TV
Check TV screws
Please select the proper screw length for your TV by hand tightening to check your flat panel thread depth.
- When attaching brackets to the flat screen, be careful not to over tighten screws and be sure that screws do not bottom out in the mounting holes
If your TV has a flat back ,AND you want your TV closer to the wall, user
the shorter screws (A)
Use the spacers and longer screws (B) to accommodate:
- Round/irregular back TVs
- TVs with inset mounting holes.
- Extra spaces needed for cables.
First, make sure the diameter of the bolt(A-F) fits your TV. Then, please see
the diagram above. You will need to thread the bolt into the TV using the
correct washer (G) and spacer (Hor I) if necessary with a screwdriver(Not
included). Please make sure the monitor brackets(04) are vertically centered
and level with each other.
cable management (Attaching wire clips)
Hang TV to the
TV Plate
Insert the Safety Lock
in the bottom of the bracket and then tighten the screws.
Height Adjustable of the TV Brackets
If you find your TV set is too close to the base, please take off the TV from
the stand. Then, change to the second choice to allow more space between TV
and the wooden base (01).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>