JENNAIR JDPSG244LS 24 Inch Built-In Dishwasher User Guide

: June 3, 2024
: JENNAIR

Table of Contents

OPERATING INSTRUCTIONS
Cycle Guide
Read User Manual Online (PDF format)
Download This Manual (PDF format)

JENNAIR JDPSG244LS 24 Inch Built-In Dishwasher

JENNAIR JDPSG244LS 24 Inch Built-In Dishwasher

| WARNING
---|---
Tip Over Hazard
Do not use dishwasher until completely installed.
Do not push down on open door.
Doing so can result in serious injury or cuts

OPERATING INSTRUCTIONS

Load dishwasher
Racks vary by model.
3rd Rack

Third Level Rack with Extra Wash

Loading Tips

Additional Loading Tips

Place plastic items, small plates, and bowls in the upper dish racks. Use adjusters for tall items.

**Add detergent. Slide lid to close. Use automatic dishwashing detergent only.

**

Add rinse aid when fill window indicator shows low about every 1 to 3 months
Select cycle & option(s).
**Press START and close door within 4 seconds (top controls) OR (front controls) close door and press START.

**

For detailed installation instruction please see the Owner’s Manual included with your machine or visit https://www.jennair.com. This may save you the cost of a service call.

Cycle Guide

JENNAIR JDPSG244LS 24 Inch Built-In Dishwasher Cycle
Guide

Options Wash Cycles

Sensor A selectable cycle that calibrates the dishwasher to use the optimal

wash cycle to clean dishes, detecting changes in water temperature. A turbidity sensor monitors water clarity and a microprocessor adjusts the water temperature to match the dish soil level
Cookware| Cookware/Bakeware cycle uses the added amount of water and heating temperature for hard-to-clean, heavily soiled pots, pans, casseroles and regular tableware.
Crystal| A selectable wash cycle that lowers wash temperature to protect your dishes
Rapid| A wash cycle for dishes with light soil, especially useful when entertaining
Refresh| Pre-rinse dishes without detergent when you’re not planning to immediately run a full wash load. Or, refresh clean dishes before guests arrive.
Normal| Clean normal amounts of food soil with the Normal cycle
PrecisionDry +| An option that uses heated drying plus a system of vents and a fan that ventilates moist air out of the dishwasher
Bottom Rack Wash| This selectable option washes dishes on the bottom rack.
Mid Rack Wash| This selectable option washes dishes on the middle rack zone and can be used with most wash cycles.
1-24 Hour Delay| Gives you the option to postpone the start of your wash cycle in one-hour increments for up to 24 hours to operate it when desired.
Sanitize Rinse| When selected, the final rinse water is heated to 155°F (68.3°C), eliminating 99.999% of food soil bacteria. This meets national requirements for household sanitization.
Hi-Temp Wash| Hi-Temp option provides an increased water temperature during washing for hard-to-remove soils.
Steam Finish| Generates a mist of steam before the final rinse cycle to help enhance shine and finish on glassware.
Start / Resume| Push to start or resume a cycle
Cancel / Drain| Push to reset any cycle or options during selection. Push to end a cycle once starte

Options	Wash Cycles
Sensor	A selectable cycle that calibrates the dishwasher to use the optimal

The government energy certifications are not based on this cycle. See the Normal cycle description for the government energy certification cycle. Using the Sensor cycle may increase your energy usage

No other washing and drying temperature options were selected, and it was not subject to truncated testing. Rinse aid was not used, and there was no detergent used in the prewash.
Not all cycles, options, and features shown are availble on all models.
Energy and water use vary greatly with installation, cycle

Adjusting Racks

canastas You can raise or lower the middle rack to fit tall items in either the middle or bottom rack. Adjusters are located on each side of the middle rack. To raise the rack: Press both rack adjuster thumb levers and lift the rack until it is in the up position and level. To lower the rack: Press both rack adjuster thumb levers and slide the rack to its down position and level.
NOTE: The middle rack must be level. Remove dishes before adjusting rack.
Filter Cleaning

Filters should be removed and cleaned every 1 – 3 months for best performance. To remove filter, pull out lower rack, grasp Filter Cup and rotate it 1/4 turn counterclockwise. Pull up to remove. Remove the Filter Plate. Rinse both under cold water in sink. A soft brush can be used to remove stuck on food. Replace filter plate. Ensure filter plate is correctly seated under tabs. To install filter cup, push down through opening. Turn clockwise to seat. Filter cup will click in to place when seated properly. Do not operate dishwasher with loose or missing filters.