EMOS ZS2412 LED Floodlight Instruction Manual

: June 3, 2024
: EMOS

Table of Contents

Models
Specification
Dimension
LED Floodlight
- Mounting
Maintenance instructions
Disposal
Support
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

EMOS ZS2412 LED Floodlight Instruction Manual

Models

ZS2412

ZS2422
Models ZS2422

ZS2432
Models ZS2432

This product contains a light source of energy efficiency class

Specification

Type	Input voltage	Max. power	Life span	Luminous flux
ZS2412	220-240 V AC
50/60 Hz	15W	50 000 h	1 700 lm	112 x 86 x 45 mm
ZS2422	30 W	50 000 h	3 500 lm	173 x 130 x 50 mm
ZS2432	50 W	50 000 h	5 700 lm	221 x 156 x 52 mm

Dimension

LED Floodlight

LED Floodlight is designed for indoor and outdoor use to be mounted on a firm ground.
Ingress Protection IP65 – for outdoor use

Mounting

Mount the Floodlight firmly onto a solid basis, for example a wall (fig. 1, 2, 3).
Installation height: 2.3–3 m.
Direct the Floodlight as shown on fig. 1 and 2.

L – brown – live wire
G – green & yellow – earth wire (ground)
N – blue – neutral wire
Mounting Instruction

Maintenance instructions

Before maintenance, switch off the Floodlight and wait until it is cooled.
Clean it with a soft moistened cloth.
Never submerge the Floodlight in water or other liquids.
During maintenance, observe general rules for occupational safety, and be very careful.

WARNING

The LED Floodlight is designed entirely for firm mounting.
Before connecting to the 220–240 V~ make sure that the connecting wire is not under voltage. This operation can be carried out only by an authorized person.
Respect a minimum distance of 1 m between the appliance and the object or surface which you wish to lighten.
If you place the Floodlight below the roof, keep the minimum 0.2 m distance measured from the upside of the Floodlight to the bottom of the roof.
When using the Floodlight on a flammable surface, observe the above instructions.
The Floodlight may only be connected to electrical mains with installation and protection that is in line with valid regulations and standards.
Before interfering with the Floodlight or performing maintenance and repair, the light fitting must be disconnected from the mains. This must only be done by a knowledgeable/experienced person within the meaning of valid regulations on qualification for such activities.
Do not use the LED Floodlight without the protection glass.
The protection from dangerous contact voltage is ensured by „earthing“.
If the external flexible cable or cord of this Floodlight is damaged, it shall be exclusively replaced by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
The light source contained in this Floodlight shall only be replaced by the manufacturer or his service agent or a similar qualified person.
Terminal block not included. Installation may require advice from a qualified person.
Terminal block for connection of power supply: 3 terminals screw type or screw-less type, rated for cross-section range including 1 mm2 and voltage min 230 V.
Caution, risk of electric shock .
Type Y attachment.

EMOS spol. s r.o. declares that the LED Floodlight is in compliance with the essential requirements and other relevant provisions of Directive. The device can be freely operated in the EU. The Declaration of Conformity can be found at http://www.emos.eu/download.

Disposal

Do not throw electric appliances into unsorted municipal waste, use collection points of sorted waste! Dangerous substances from electric appliances deposited in landfills can leak into underground waters, reach the food chain and damage your health and well-being. For actual information about collection points, contact the local authorities.