airlive PJ-1001-30W PoE Injector User Manual
- June 6, 2024
- airlive
Table of Contents
PoE Injector
User Manual
PJ-1001-30W
Copyright & Disclaimer
No part of this publication may be reproduced in any form or by any means,
whether electronic, mechanical, photocopying, or recording without the written
consent of AirLive Technology Corp.
AirLive Technology Corp has made the best effort to ensure the accuracy of the
information in this user’s guide. However, we are not liable for the
inaccuracies or errors in this guide. Please use with caution. All information
is subject to change without notice
All Trademarks are properties of their respective holders.
Disposal
This marking indicates that this product should not be disposed of with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmentally safe recycling.
Overview
Ethernet 802.3at PoE Injector (PJ-1001-30W)
The AirLive PJ-1001-30W Gigabit Ethernet POE Injector is fully compatible with
IEEE802.3af (15.4W) and IEEE802.3at (30W). The POE port supports a maximum
output power of 30W, and the port supports 10/100/1000Mbps self-adaption. It
supports AC 100-240V voltage input; the working temperature range is -20°C ~
+50°C, seamless ultrasonic bonding, better protection effect. It takes the
electricity from the power source and the data from the Ethernet network and
then combines them into a signal that can be transmitted through the UTP/STP
cable up to 100m.
The product can be widely used in IP Camera, AP, 30W PoE PC-Panel, AP, digital
signage display system, PoE LED, etc. Its reliable hardware design can ensure
your automation system runs without interruption and stability.
AirLive PoE Injector
1.1 Connecting PJ-1001-30W
Power on the device by connecting the AC cable first. Connect an RJ-45 cable
from a switch/router to the PoE Injector’s port called Data In, this is Data
only. From the PoE Injector’s PoE Out port RJ-45 cable can now be used to
Power On and transfer Data for, for example, a PoE Camera or Access Point. The
PoE Out port has both Power and Data.
For more detailed specifications please see the datasheet.
The datasheets can be found online on
www.airlive.com
** Specifications are subject to change and improvement without notice.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>