EMOS ZS2452 LED Floodlight Instruction Manual
- June 3, 2024
- EMOS
Table of Contents
EMOS
ZS2452 LED Floodlight Instruction Manual
1531246200_31-ZS2462_00_01 148 × 210 mm
Zdroj: 1531245200_31-ZS2452_00_01.indd
ZS2452
ZS2462
ZS2472
LED Floodlight
ZS2452 LED Floodlight
ZS2452
ZS2462
ZS2472
Type| Input voltage| Max. power| Life span| Luminous
flux| Dimensions
---|---|---|---|---|---
ZS2452| 220-240 V AC
50/60 Hz| 100 W| 50 000 h| 13 000 lm| 321 x 280 x 60 mm
ZS2462| 150 W| 20 000 lm| 321 x 280 x 60 mm
ZS2472| 300 W| 40 000 lm| 321 x 465 x 64 mm
This product contains a light source of energy efficiency class
LED Floodlight
LED Floodlight is designed for indoor and outdoor use to be mounted on a
firm ground.
Ingress Protection IP65 – for outdoor use
Mounting
Mount the Floodlight firmly onto a solid basis, for example a wall (fig. 1, 2, 3). Recommended mounting height 6–7 m. Direct the Floodlight as shown on fig. 1 and 2.
L – brown – live wire
N – blue – neutral wire
G – green&yellow – earth wire (ground)
Maintenance instructions:
Before maintenance, switch off the Floodlight and wait until it is cooled.
Clean it with a soft moistened cloth.
Never submerge the Floodlight in water or other liquids.
During maintenance, observe general rules for occupational safety, and be very
careful.
WARNING
- The Floodlight is designed entirely for firm mounting.
- Before connecting to the 220–240 V~ make sure that the connecting wire is not under voltage. This operation can be carried out only by an authorized person.
- Respect a minimum distance of 1 m between the appliance and the object or surface which you wish to lighten.
- If you place the Floodlight below the roof, keep the minimum 0.2 m distance measured from the upside of the Floodlight to the bottom of the roof.
- When using the Floodlight on a flammable surface, observe the above instructions.
- The floodlight may only be connected to electrical mains with installation and protection that is in line with valid regulations and standards.
- Before interfering with the Floodlight or performing maintenance and repair, the light fitting must be disconnected from the mains. This must only be done by a knowledgeable/experienced person within the meaning of valid regulations on qualification for such activities.
- Do not use the Floodlight without the protection glass.
- The protection from dangerous contact voltage is ensured by „earthing“.
- If the external flexible cable or cord of this Floodlight is damaged, it shall be exclusively replaced by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
- The light source contained in this Floodlight shall only be replaced by the manufacturer or his service agent or a similar qualified person.
- Terminal block not included. Installation may require advice from a qualified person.
- Terminal block for connection of power supply: 3 terminals screwtype or screw-less type, rated for cross-section range including 1,0 mm 2 and voltage min 230 V. For installation with connecting dimming control wires additional 2 terminals are required.
- Caution, risk of electric shock .
- Type Y attachment.
EMOS spol. s r.o. declares that the LED Floodlight is in compliance with the
essential requirements and other relevant provisions of Directive. The
device can be freely operated in the EU. The Declaration of Conformity can be
found at http://www.emos.eu/download.
Do not throw electric appliances into unsorted municipal waste, use collection points of sorted waste! Dangerous substances from electric appliances deposited in landfills can leak into underground waters, reach the foodchain and damage your health and well-being. For actual information about collection points, contact the local authorities.
Service:
EMOS SI, d.o.o., Rimska cesta 92, 3311 Šempeter in Savinjska dolina, Slovenia
phone: +386 8 205 17 21, reklamacie@emos-si.si
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>