HiCOZY CB23H Bullet Ice Maker User Manual

HiCOZY CB23H Bullet Ice Maker

INTRODUCTION

This product is designed to make bullet-shaped ice suitable for cooling, preserving, and refreshing food and drinks. It’s great for use in kitchens, living rooms, parties, and more.
To get the best performance from your new bullet ice maker,please carefully read and follow all the instructions in this manual before use.

We hope you enjoy your new HiCOZY Bullet Ice Maker!

Thank you again for choosing HiCOZY. Questions or concerns?
You are welcome to contact us via support@hicozy.com

Please fully read and understand this manual before using and keep this manual for future reference.

WARNING

• It is recommended to use chilled water for faster ice production.
• Before using, ensure the power outlet’s voltage corresponds to the value shown on the appliance nameplate. The wrong voltage will damage the product.
• The product should always be grounded correctly. Only use a grounded power strip with a power rating greater than 1000 W.
• Leave at least 4 inches of (10.2 cm) clearance on all sides of the ice maker for proper ventilation.
• Do not attempt to disassemble, repair, modify, or replace any part of this product.
• Before using the ice maker for the first time or after moving it,please place the ice maker on a level surface and wait for 6 hours.
• After 6 hours in the proper position, the ice maker can be used normally.
• Before operation, we recommend cleaning the ice maker as outlined in the “Cleaning’ section on page 14 of this manual.
• Do not turn the ice maker upside down, this may cause the compressor and/or refrigeration system to malfunction.
• Only use this product with potable/drinkable water, failure to do so is hazardous to users’ health.
• Do not use hot water in this product.
• Always use water that is under 86 °F (30 °C).
• Do not immerse any part of the product into water, or touch the plug with wet hands.
• To avoid frostbite, do not touch the ice-making parts while in use.
• Do not use this product in outdoor, hot, or corrosive environments.
• Always use this product on a dry, even, and stable surface.
• The incline angle of the ice maker cabinet should not exceed 45° during transportation or use.
• Do not allow children or persons who lack experience and knowledge to use the product.
• When not in use, please drain the water tank and dry the product with a clean towel. Then, store it in a dry and well-venti-lated place.

PACKAGE CONTENT

• Ice Maker × 1
• Ice Scoop  × 1
• User Manuall  × 1
• Warranty Card  × 1

DIAGRAM

1. Control Panel

2. Ice Basket

3. Heat Dissipation Vent

4. Power Cord

5. Drain Hole

6. Drain Plug

7. Ice Scoop

8. LED Light

9. Ice-Producing Port

10. Ice-Making Part

11. Ice-Making Box

12. Infrared Sensor

13. Max Water Level

14. Water Tank

15. Filter

16. Fan

SPECIFICATIONS

• Ice-Making Time
  6-10 Mins

• Ice Basket Capacity
  1.6 lbs (750 g)

• Water Tank Capacity
  950 ml

• Electrical Rating
  AC 120 V/60 Hz/1.5 A

• Power
  110 W

• Weight
  15 lbs (7 kg)

• Dimensions
  Length 7.3 × Width 12.8 x Height 11.6 in (18.5 × 32.5 × 29.5 cm)

• Refrigerant Amount
  R600a/30 (+/-0.2) g

INSTALLATION

1. Open the package and take out all the accessories.
2. Place the ice maker vertically on an even surface.
3. Use a clean towel to wipe the water tank, ice basket, and ice scoop.
4. Keep the ice maker upright for 6 hours before the first use.

BUTTON FUNCTIONS

BUTTON & INDICATOR INSTRUCTIONS

Power Button
Press the button to turn the ice maker on/off.

Mode/Light Button

• Mode function:
  Press to switch ice modes, large ice or small ice.

• Light function:
  Press and hold the button for 3 seconds to turn the light off. Press and hold the button for 3 seconds to turn it on.

Start/Pause Button

• Start/Pause function:
  Press to start/stop ice making after selecting the desired ice-making mode.

• Cleaning function:
  Press and hold for 3 seconds to start cleaning mode, press it again to stop cleaning.

• Water Shortage
  This indicator illuminates when the water level is low.

• Full Ice Basket
  This indicator illuminates when the ice basket is full.

• Large Ice Mode
  This indicator flashes when choosing the large ice mode.
  After the machine starts making ice, the indicator will stay illuminated.

• Small Ice Mode
  This indicator flashes when choosing the small ice mode.
  After the machine starts making ice, the indicator will stay illuminated.

• Cleaning Mode
  After starting the cleaning mode, the indicator will stay illuminated.

INSTRUCTIONS

ADD WATER

1. Place the ice maker upright for more than 6 hours before the first use.

2. Ensure the drain hole is blocked by the drain plug.

3. Pull out the ice basket and ensure it securely rests on the edge of its slot.

4. Slowly pour 950 ml of drinkable water into the ice basket.
   (Note: do not exceed the MAX water level.)

5. Push the ice basket securely back into place.

PLUG IN

1. Check that the power outlet’s voltage corresponds to the value shown on the appliance nameplate.
2. After plugging in, all the indicators will flash for 1 second and then turn off.
   Note: Do not use wet hands to plug in the machine. Keep the plug dry.

Note:

1. If the product has been idle for a long time or if using it for the first use, please refer to the “Cleaning” section on page 14.

2. It takes approximately 6-10 minutes to make ice. The duration may fluctuate based on the ice size, ambient temperature, and water temperature.

3. The ice may come out small in the beginning, this is normal.
   This is usually because the interior cooling pipes have not completely cooled yet. This is normal and will resolve after a few minutes.

4. The ice maker stops making ice after the ice basket is full.
   The product will resume making ice once the basket is no longer full.

DRAIN WATER

1. Disconnect the power plug before draining.

2. Carefully move the ice maker to an area appropriate to drain water into, like a sink.
   Note: Move it evenly to avoid falling.

3. Disconnect the drain plug and ensure the residual water flows into the appropriate area.

4. After the water tank is empty, securely plug in the drain plug.
   Use a clean towel to wipe the residual water.

5. Put the ice maker back.

Drain out water in the following situations:

1. Always use fresh drinking water to make ice, excess water should be drained after every use.
2. When the product will be idle for a long time.

CLEANING

To keep your ice tasting fresh and your ice maker clean, we recommend cleaning your ice maker at least once per week.
Pull out the ice basket, add some citric acid and water to the water tank. Then, put the ice basket back.

Note: Do not use organic solvents, boiled water, strong acids, or bases for cleaning.

1. Press and hold the Start/Pause Button for 3 seconds, the cleaning indicator will illuminate and the cleaning mode will start. After 15 minutes, it will stop cleaning. The Start/Pause Button can be pressed to manually stop the cleaning.

2. Disconnect the drain plug after the cleaning has stopped.
   After it drains, tightly plug the drain plug back in.

3. Add some fresh drinking water to clean the product, activate the cleaning mode, and repeat these steps 2-4 times to ensure there is no residual cleaner in the machine.

Note: To avoid safety hazards, keep the interior components dry.
Do not use solvents or chemicals to wipe the plastic parts.

TROUBLESHOOTING/FAQ

THE ICE MAKER DOES NOT WORK.

1. Check if the product is powered correctly.
2. Check if the water tank has sufficient water.
3. Check if the compressor works.

THE ICE MAKER LEAKS.

1. Do not exceed the MAX water level when adding water.
2. Check if the drain plug is tightly plugged.

WITH SUFFICIENT WATER, THE PRODUCT DOES NOT PRODUCE ICE.

1. Check if the water tank’s filter is blocked.
2. Check if the compressor works.

THE FULL ICE INDICATOR ILLUMINATES WHILE THE ICE BASKET IS NOT FULL.
The infrared sensor is blocked by ice, remove excess ice.

RECYCLING
This product contains a refrigerant, which under Federal Law must be removed prior to product disposal.
Legally dispose of the product according to the local regulations.

WARRANTY PERIOD

1-YEAR LIMITED WARRANTY FROM HiCOZY
If the ice machine fails due to a defect in materials or workmanship,during the limited one-year warranty. HiCOZY will either replace your product with a new or remanufactured product or refund the purchase price of the product at HiCOZY’s sole discretion,

What HiCOZY will not cover:

• Service trips to your home.
• Improper maintenance.
• Replacement house fuses or resetting of circuit breakers.
• Incidental or consequential damage caused by possible defects with this appliance.
• Labor and other charges to install and/or remove the product.

Each HiCOZY ice maker will be free from defects in material and craft. This warranty does not cover damage from neglect, misuse,contamination, alteration, accident, or abnormal conditions of operation or handling. This warranty covers the original purchaser only and is not transferable.

HiCOZY always wants to provide our customers with excellent products and customer service.

Questions or concerns? You are welcome to contact us via support@hicozy.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>