REGENCY 460EG2436WSK Wire Wall Shelving Kit Instruction Manual

Table of Contents

$REGENCY-460EG2436WSK-Wire-Wall-Shelving-Kit-FIG- $2$$

The Wire Wall Shelving Kit is a versatile storage solution for organizing and displaying items. It includes the following parts:

Lay out all parts to ensure all are included and undamaged.
Determine shelf placement and note the desired height.
Place the first wall bracket at the desired height on the wall. Level the bracket and mark the mounting holes.
Drill a hole at least 1 5/8″ deep in the center of each mark using a 3/8″ masonry drill bit. Avoid drilling into mortar joints if the wall is a block wall.
Insert the threaded bolt into the bottom of the sleeve anchor. Push the anchor into the drilled mounting hole. Repeat for all four holes. Note that the threaded portion of the bolt should be sticking out of the mounting hole.
Place the mounting bracket (with the loops facing up) over each threaded bolt. Install a flat washer, lock washer, and hex nut over each bolt in that order. Use a 10mm wrench to tighten the hex nuts so that the mounting bracket is flush with the wall.
Use a tape measure and level to determine where to install the second mounting bracket based on the shelf size.
Repeat steps 3-6 for the second mounting bracket.
Once both brackets are secure, install the shelf by inserting the corners over each of the loops on the mounting brackets.
Test the shelf weight and ensure it is level. Installation is complete.

For more information, please visit www.RegencyTablesandSinks.com

TOOLS SUGGESTED (NOT INCLUDED) $REGENCY-460EG2436WSK-Wire-Wall-Shelving- Kit-FIG- $3$$

$REGENCY-460EG2436WSK-Wire-Wall-Shelving-Kit-FIG- $4$$

$REGENCY-460EG2436WSK-Wire-Wall-Shelving-Kit-FIG- $5$$

Lay out all parts to ensure all are included and undamaged.
Determine shelf placement and note desired height.
Place the first wall bracket at the desired height on the wall. Level the bracket and mark the mounting holes.
Drill a hole at least 15/8” deep in the center of each mark using a 3/8” masonry drill bit.
NOTE : Avoid drilling the hole into the mortar joints of the wall if the wall is a block wall.
Insert the threaded bolt into the bottom of the sleeve anchor as shown. Push the anchor into the drilled mounting hole. Repeat for all four holes.
NOTE : The threaded portion of the bolt should be sticking out of the mounting hole.
Place the mounting bracket (with the loops facing up) over each threaded bolt and then install a flat washer, lock washer, and hex nut over each bolt in that order. Use a 10 mm wrench to ensure the hex nuts are tightened so that the mounting bracket is flush with the wall.
Use a tape measure and level to determine where to install the second mounting bracket based on shelf size.
Repeat Steps 3 – 6 for the second mounting bracket.
Once both brackets are secure, install the shelf by inserting the corners over each of the loops on the mounting brackets. $REGENCY-460EG2436WSK-Wire-Wall-Shelving-Kit-FIG- $6$$
Test shelf weight and ensure the shelf is level. Installation is complete.