INFINITY WiFi Module for Proteous Range User Manual

INFINITY WiFi Module for Proteous Range

INSTALLATION

1. Disconnect the power supply to the control unit
2. Insert the module into the ADI port of the control unit
3. At the first installation, make sure that the module is in access point mode (RED LED ON STEADY)
4. Then proceed to enroll the control panel to the server following the instructions provided by the V2 GO APP
   NOTE: If the module is not in access point mode, reset the module using the reset procedure: press the reset button for 3 seconds, the LED must go out and light up again, remaining steady red.

STATUS OF LED

• FIXED RED: The module is in Access Point mode, waiting for a connection
• FLASHING RED: mismatch between the serial of the control panel and the serial stored in the module. Perform the module reset procedure
• FIXED BLUE: STA mode, module connected to the server

ENTER YOUR HOME WITHOUT LIFTING A FINGER

GEOLOCATION-BASED OPENING
Activate the GPS and the gate will open automatically as soon as it has detected the presence of your Smartphone at the set distance (250m / 500m/1000m options).

SET UP PROGRAMMED SCENARIOS TO BE RUN ANYTIME YOU WANT

BUILT-IN TIMER
Set new scenarios according to your needs, choosing for each one whether to activate it manually or automatically at a specific time/day.

ACCESS MANAGEMENT FROM YOUR SMARTPHONE
APC Infinity allows you to check all the opening and closing maneuvers of your gate, anywhere you are.

CHECK AT ANY TIME WHO COMES AND GOES

APC Infinity lets you manage all access straight from your smartphone by giving specific time slots to who you want when you want. Also from remote .

KEEP EVERYTHING ALWAYS UNDER CONTROL

Even when you are not at home, APC Infinity allows you to check at any time whether your gates are open, closed or moving.

PERMISSION

• Remotely manage the automation: you can control the gate, garage, rolling shutters and lights even when you are not at home
• Geolocation: you can decide to receive a notification when you approach the chosen automation or automatically activate it when you are getting close to it (automatic mode).
• Remotely check the status of your automation (Did I close my gate, or did I leave it open?) and the latest movements (when was the last time it was opened?)
• Permissions: grant other users the use of one or more of your automation, but only in the time slot you decide.
• Brings together all the home control automation in a single device: lights, garage, gate, rolling shutters and curtains.
• Set new scenarios according to your needs, choosing for each one whether to activate it manually or automatically at a specific time/day

FULL REMOTE CONTROL OF THE AUTOMATION

• Opening
• Closing
• Stopping
• Managing outputs
• Geo fence management of the automation
• Knowing the status of the automation (opened ,closed, % opened, stopped)

FULL ACCESS CONTROL FEATURES

• Dening the users that can have access to the site
• Limiting user access in time (hour, day, week and month)
• Log and record every access of each user
• Adding/Blocking/Deleting users

AUTOMATIC SETUP OF SCENARIOS

• Opening and closing with scenarios
• Each scenario can be performed under a timing (specic hours of the day, daily, monthly, specic day of the year)
• Managing multiple automation with one single command/scenario

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>