SellEton SL-60KX Heavy Duty 7′ Truck Axle Scale Installation Guide
- June 3, 2024
- selLEton
Table of Contents
Scoles.com
Installation Instruction for Axle Scales
SL-60KX Heavy Duty 7′ Truck Axle Scale
Scale Components
Bolts details
| bolt for load cell M24 x 75 mm (total: 16 pcs)
---|---
| expansion bolt M16 x 100 mm (total: 28 pcs)
| Limit bolt M20 x 70 mm (total: 8 pcs)
| bolt for bending plate (total: 16 pcs)
| M16 eyebolt (total: 2 pcs)
Tools Required for Installation
-
Make sure the complete installation is done on a level ground .
-
Bolt the installation plate to the ramps and place the ramps 87″ apart in parallel with forklift .
-
Bolt the installation plates to the platform and screw the four threaded level feet into the four corners of the platform while lifting it with the forklift .
-
Place the platform between the two ramps, making sure all the feet sit inside the rings on the ramps .
If necessary, adjust the height with a screwdriver from the top. -
Pull out the interface cable Open the cover on the side and you will find the junction box with a 50ft long cable nested inside. Run the cable (with connector) through hole on the bottom and pull it out from underneath as long as you need . Close the cover with the original screws after this is finished .
-
Follow the same steps to install the other set .
-
Plug the connectors on the interface cables to the 2 ports of the indicator .
-
For permanent use, install anchoring bolts to the ramps .
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>