sellEton SL-700 Floor Scale User Guide
- June 5, 2024
- selLEton
Table of Contents
sellEton SL-700 Floor Scale
Instructions
Inside Scale:
- (1) Homerun Cable
- (1) Indicator w/ U-bracket
- (1) AC Adapter
- (1) Indicator manual
- (4) Screw in Feet
-
Carefully open box and remove the scale
-
Locate access compartment (Top or Side) and remove the screws
-
Remove all contents from the inside compartment
NOTE: any upgrades to the order will be shipped separately, ie. indicator w/battery -
Route the homerun cable through the cable opening located inside the compartment near the underside of the scale
-
Close compartment latch with screws
-
Screw-in all 4 feet into the 4 load cells located on the underside of each corner
NOTE: Do not screw in too deep that it will touch the platform -
Place scale on flat surface, if not level, lift scale slightly and adjust scale feet with a screwdriver through the feet access openings until the scale is stable
-
Connect the home run cable to the indicator
-
Plug the AC adapter to the indicator and power on the indicator
-
Once the indicator is powered on, the display will count down and show zero
-
To ensure your scale is level, place an item you know the weight of on each corner of the scale, if a corner varies, adjustments to the feet should be made
-
Your scale is ready for use (no calibration is needed)
-
If the weight is incorrect, calibration will be needed
NOTE: Please refer to your indicator manual for proper calibration steps
CONTACT US
Please call 844-735-5386 for
information
For updated indicator manual, please refer to
www.selletonscales.com/pages/downloads
info@selletonscales.com
844)-735-5386
www.selletonscales.com