hoymiles DTU-WLite Data Transfer Unit Installation Guide
- June 3, 2024
- hoymiles
Table of Contents
hoymiles DTU-WLite Data Transfer Unit Installation Guide
Interface Layout
Preparation
A) Download the Hoymiles mobile installer App
B) Check the box for the following items:
✓ Hoymiles DTU-WLite
Installation
A) Power the DTU- WLite
Option 2: Connect the DTU to the adapter and plug it into the Power
Strip. Please make sure it is placed at least 0.5 meter above the ground and
try to install the DTU 90 degrees vertical to the ground as much as possible.
Note: Please do not install the DTU directly above the metal or concrete
to prevent the signal dilution.
B) Start Procedure
Once the DTU powers on, the red, green and blue lights will flash for one
second in turns for 30 seconds.
C) Set up with Internet
Use the smart phone/tablet open the Installer App and login. Approach to “O&M”
on the bottom of the page and then “Network Configuration”. And complete the
Wi-Fi configuration.
Installation Map
Please complete the installation map.
A) Peel the serial number label (as circled below) from the DTU and place it
on the installation map.
B) Complete system information of the installation map shown as follows.
Online Setting
Please complete the online account creation to complete the DTU installation
(You can refer to “Quick Installation Guide for HMP Online Registration” for
detail account creation steps).
Note: For more setting details regarding the Local Install Assistant
please acquire the related Operation Guide from our Tech. Support Team at
[email protected].
Warning
Warning
- Only qualified personnel can install or replace the DTU.
- Do not attempt to repair the DTU as it contains the parts that are not serviceable to users. If the DTU breaks down, please contact your distributor for maintenance. Open the DTU without permission will invalidate the warranty.