DOMUS Lighting CHAM-REM-1C Bluetooth Remote Control Installation Guide
- June 12, 2024
- DOMUS LIGHTING
Table of Contents
DOMUS Lighting CHAM-REM-1C Bluetooth Remote Control
Thank you
Thank you for purchasing your new CHAM-REM-1C Remote control, Please take the time to read and understand the instruction sheet below. Failure to do so may void warranty
Specifications
Type of controller:| Single colour dimming remote control| Remote size (mm):|
(L) 150mm x (W) 38.6mm x (D) 12mm
---|---|---|---
Protocol:| RF + Bluetooth| Transmission frequency:| 2.4GHz
Dimming range:| 0.1% – 100%| Transmission range:| 30m
Remote colour:| Black| Operation voltage:| 3VDC (CR2025)
- RF+Bluetooth DIM Remote Control
- Single color remote control to control 3 zones of receivers and 4 scenes
- Easy & quick pairing to the RF+Bluetooth receivers by simply pushing the buttons
- Mesh network for further control distance, receivers can transmit signal to each other
- Each remote can control numerous receivers
- Each receiver can be paired to max. 8 remote controls
- The controlled receiver status can be quickly synchronized to the smart APP
- Transmission range between every two neighbor devices up to 30m
- • Bluetooth low power consumption technology, long battery life
- With magnet on the back, easy fasten to & remove from the bracket
Safety & Warnings
- This device contains a button lithium battery that shall be stored and disposed properly.
- DO NOT expose the device to moisture
Pair with RF+Bluetooth receiver
Step 1: Do wiring the receiver according to wiring diagram (please refer to the instruction of RF receiver that you would like to pair with).
Step 2: Click the “Prog. Key” or “Reset” button on RF+Bluetooth receiver (or reset power of the receiver 3 times continuously if the button is not accessible) to set it into pairing to RF remote status
Step 3: Choose one zone and click “I” or “O” of the zone (e.g. zone 2), LED lights connected with the receiver flicker once means the receiver is paired with zone 2 successfully.
Note: one receiver can be paired with max 8 remote controls.
If you use multiple receivers, you have two choices:
Option 1: have all the receivers in the same zone, like zone 1
Option 2: have all the receivers in different zones, like zone 1, zone 2, zone
3
Note:
- The lamp must be installed by professional electrician
- Ensure the power supply is switched off before fitting this product
- Do not touch the lamp when in use
- Keep away from hot steam and corrosive gas
How to save and recall scenes
Step 1: Make sure that lighting devices have already been paired to the 3
groups that you would like to save scenes for.
Step 2: Press and hold “I” or “O” button of the 3 groups to adjust a
desired brightness for each individual group.
Step 3 : Press and hold down a scene button (e.g. S1) until LED lights
blink to save the brightness for each individual group at the same time.
Step 4: Repeat above 3 steps, and adjust another brightness for each
individual group, then press and hold the another scene button (e.g. S2) to
save the brightness for each individual group at the same time. Totally 4
scenes can be saved for each individual group.
Recall the Saved Scenes
Step 1: Short press button S1/S2/S3/S4 to recall a saved scene for each individual group at the same time.
Customer Support
29-31 Richland St. Kingsgrove. Sydney NSW 2208 Australia
Phone: 02 9554 9600 | Fax: 02 9554 9433
enquiries@domuslighting.com.au |
www.domuslighting.com.au
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>