GARMIN TT15 Mini Dog Collar Device User Manual

TT™ 15X/TT 15 MINI DOG COLLAR DEVICE
Quick Start Manual

Getting Started

WARNING
See an Important Safety and Product Information guide in the product box for product warnings and other important information.

Dog Collar Device

NOTE: Your dog collar device may look different than the device pictured.

1. VHF antenna
2. GPS antenna
3. Power button
4. Contact points
5. Status LED and flashing beacon LEDs

Turning On the Device

• On the dog collar device, hold the power button until the status LED flashes and the collar beeps.

Turning Off the Dog Collar Device
Hold the power button until the status LED turns solid red and the device beeps.
Charging the Dog Collar Device

NOTICE
To prevent corrosion, thoroughly dry the contacts on the collar and the surrounding area before connecting the charging clip.

NOTE: Your dog collar device may look different than the device pictured. You should fully charge the battery before you use the device for the first time. Charging a fully depleted battery takes about five hours.

1. Snap the charging clip 1 onto device 2.

2. Plug the small end of the power cable into the mini-USB port on the charging clip cable.

3. Plug the power cable into a power source. The status LED is solid red when the collar is charging.

4. After the status LED turns solid green, remove the charging clip from the collar.

Acquiring Satellite Signals

Both the collar and handheld device must acquire satellite signals before you put the collar on your dog. Acquiring satellites can take a few minutes.

1. Go outdoors to an open area.
2. Turn on both devices. in the status bar shows the GPS signal strength.
   When the collar has acquired satellite signals, the status LED flashes a double-blink or triple-blink in green.

Adding a Dog to the Alpha® Handheld Using Wireless Pairing

1.  If the dog collar device is on, turn it off the dog collar device.

2. Hold the power key on the dog collar device until the device emits two series of beeps (about 2 seconds), and then release the power button.
   The status LED flashes rapidly in green. The dog collar device is now ready to be linked, or paired, with a handheld device.

3. On the handheld device, select Dog List > Add Dog.

4. Select an option:
   • If you are near the dog collar device, select Pair Collar, and follow the on-screen instructions.
   • To pair a dog collar device by receiving the information from another handheld device, select Receive from Handheld.
   NOTE: To successfully pair the device, the other handheld device must wirelessly share the dog collar device information.

5.  After successfully adding the dog collar device, enter the name of the dog, and select .

Selecting and Installing the Contact Points

CAUTION
To prevent irritation from the contact points, remove the collar for at least eight hours out of every 24-hour period.
Do not spray the device or collar with harsh chemicals including but not limited to flea or tick spray. Always ensure that any flea or tick spray that is applied to the dog is completely dry before placing the collar on the dog. Small amounts of harsh chemicals can damage the plastic components and collar laminate.

For best results, select the correct contact points based on your dog’s coat.

1. Select the correct contact point length for your dog’s coat type:
   • For dogs with thicker coats, use the longer contact points.
   • For dogs with shorter coats, use the shorter contact points.

2. If necessary, use the included wrench to remove the contact points.

3. Twist the contact points into the collar.

4. Tighten with the included wrench, but do not overtighten.
   When you put the collar on the dog, make sure the contact points are tight against the neck.

Fitting the Collar on Your Dog

CAUTION
To prevent irritation from the contact points, remove the collar for at least eight hours out of every 24-hour period.
This device is not intended for human use. Do not attempt to use on any person.
Do not spray the device or collar with harsh chemicals including but not limited to flea or tick spray. Always ensure that any flea or tick spray that is applied to the dog is completely dry before placing the collar on the dog. Small amounts of harsh chemicals can damage the plastic components and collar laminate.

In order to effectively train the dog, the collar and device must fit the dog properly. If the collar is too loose or positioned incorrectly, stimulation may be inconsistent. This can delay or prevent successful training.

1. Position the device at the front of the dog’s neck, with the status LED facing toward the dog’s chin and the contact points against the throat.

2. Tighten the strap so that it is very snug around the dog’s neck, and fasten the buckle.
   NOTE: The collar should fit tightly and should not be able to rotate or slide on the dog’s neck. The dog must be able to swallow food and water normally. You should observe your dog’s behavior to verify that the collar is not too tight.

3. Wiggle the device to work the contact points through the dog’s coat.
   NOTE: The contact points must have contact with the dog’s skin to be effective.

4. If the strap is too long, cut off the excess, leaving at least 8 cm (3 in.) to spare.
   TIP: You can mark the hole used to fasten the buckle for future reference.

Dog Tracking and Training
One handheld device can track multiple dog collar devices and other handheld devices.
Dog Tracking
The handheld device allows you to track your dog or multiple dogs, using the tracking compass or map. The map displays your location and your dog’s location and tracks. The compass pointer indicates the direction of the dog’s current location.

Dog Training

NOTICE
You should research and investigate the training methods best suited for you, your dog, and your needs. This manual provides some basic guidelines for training, but each dog has unique training needs. When used properly, the Alpha training system is a very effective training tool to aid your dog in reaching its full potential. The use of the training system should be part of an overall training program. Begin training your dog on a leash, without the Alpha training system. You should train your dog how to heel, sit, and come to you. After the dog understands these three basic commands, you can begin training with the dog collar device and the leash. Finally, when the dog consistently obeys commands using the leash and collar, you may be able to remove the leash to train with only the dog collar device.

Communication with the Collar

You should keep an unobstructed line of sight between your handheld device and the dog collar device to produce the best communication signal. To achieve the best line-of-sight conditions, you should move to the highest elevation point in your area (for example, on the top of a hill).

Entering Sleep Mode

NOTE: This feature is not available with all dog collar device models.
Before you can enter sleep mode, you must track your dog’s location using the compatible dog collar device. When connected with the handheld device, the dog collar device can be put into sleep mode to conserve the battery when you are not actively tracking your dog.

1. Select Dog List.
2.  Select a dog.
3. Select > Adjust Collar Sleep Mode > Sleep.

Exiting Sleep Mode
NOTE: This feature is not available with all dog collar device models. You can exit sleep mode on the compatible dog collar device while you are not actively tracking your dog.

1. Select Dog List.
2. Select a dog.
3. Select > Adjust Collar Sleep Mode > Wake.

Device Information

Getting the Owner’s Manual
You can get the latest owner’s manual from the web.

1. Go to www.garmin.com/support.
2. Select Manuals.
3. Follow the on-screen instructions to select your product.

Updating the Dog Collar Device Software
Before you can update the dog collar device software, you must connect the dog collar device to a computer.
NOTE: PC only. Updating the software does not erase any of your data or settings.

1. Go to www.garmin.com/products/webupdater.
2. Follow the on-screen instructions.

VHF Radio Information
This product may be used only on specific radio frequencies, which vary depending on the country of use. The handheld device and the dog device allow the user to install a different antenna. Changing the antenna can result in improved radio performance and higher radiated power. You must not use the device with a third-party antenna or an antenna not approved by Garmin®. Go to www.garmin.com/tracking-legal for details about the performance and radiofrequency of this product, lawful accessories, and power limits for countries.

Securing the Antenna and Antenna Keeper to the Collar
NOTICE
When using cable ties, ensure no sharp edges are in contact with your dog’s skin. You can secure the antenna and antenna keeper to the collar to optimize the fit of the dog collar device on your dog.
For maximum radio performance, the antenna should be pointed straight up when positioned on your dog. Depending on the size of your dog’s neck, you may need to use cable ties to properly position the antenna.

1. Secure the antenna keeper 1 to the collar with one of the provided cable ties 2.

2. Secure the antenna 3 to the collar with one of the provided cable ties 4.

3. Cut off the excess length from the cable ties.

Dog Collar Device Specifications

dBm maximum
EU SAR| 0.06 W/kg simultaneous torso, 0.07 W/kg simultaneous limb

Mini Dog Collar Device Specifications

dBm maximum

support.garmin.com
© 2022 Garmin Ltd. or its subsidiaries
Garmin®, the Garmin logo, and Alpha®
are trademarks of Garmin Ltd. or its subsidiaries, registered in the USA and other countries. TT™
is a trademark of Garmin Ltd. or its subsidiaries. These trademarks may not be used without the express permission of Garmin.
Other trademarks and trade names are those of their respective owners.

February 2022
GUID-14E2142C-D365-473D-8F24-42E687C0BDC9 v7

References

• Garmin Customer Support
• Garmin International | Home
• Garmin International | Home
• Astro, Alpha, Atemos Tracking | Garmin

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>