Bona Belt Service Kit Instruction Manual
- June 3, 2024
- Bona
Table of Contents
Belt Service Kit
Instruction Manual
Belt Service Kit
HOW TO CHANGE ABRASIVE WITH THE ARBOR WRENCH
Tools you need: Arbor wrench
Before starting, make sure that the machine is switched off and the power
cord disconnected from the socket.
STEP 1
Insert the arbor wrench into the hole below the ten- sion roller and press it
down to reduce the tension of the abrasive.
STEP 2
Pull out the old abrasive and replace it with a new one.
STEP 3
Remove the arbor wrench to increase the tension of the new abrasive.
HOW TO ATTACH THE CABLE HOLDER
Tools you need: No tools needed
Before starting, make sure that the machine is switched off and the power
cord disconnected from the socket.
STEP 1
Insert the cable holder in the center hole on the handle.
STEP 2
Fold down the cable holder and insert the cable into the holder.
HOW TO ATTACH THE DUSTBAG
Tools you need: No tools needed
Before starting, make sure that the machine is switched off and the power cord
disconnected from the socket.
STEP 1
Slide the dustbag over the tube.
STEP 2
Tie it to the tube using the strings on the dustbag.
HOW TO ATTACH THE HINGE FOR SIDECOVER
Tools you need: Wrench
Before starting, make sure that the machine is switched off and the power cord
disconnected from the socket.
STEP 1
Remove the old hinge.
STEP 2
Install the new hinge on the machine.
STEP 3
Install the new hinge on the sidecover and adjust the length of the
screw.
STEP 4
Mount the sidecover on the machine.
STEP 5 Check that the sidecover sits correctly on the machine.
HOW TO REPLACE THE POLY-V BELTS
Tools you need: Arbor wrench
Before starting, make sure that the machine is switched off and the power cord
disconnected from the socket.
STEP 1
Insert the arbor wrench into hole of the belt tension. STEP 2
Pull it upwards to lower the motor and reduce the tension of the belt.
STEP 3
Remove the old Poly-V belts.
STEP 4
Install the new belts.
STEP 5
Increase the tension of the Poly-V belts by raising the motor back into
position.
STEP 6
Remove the arbor wrench and place it back in the arbor wrench holder.
Watch the instruction videos here!
https://www.bona.com/service-kit-belt
Bona.com