8BitDo Lite2 Bluetooth Gamepad Instruction Manual
- June 15, 2024
- 8Bitdo
Table of Contents
8BitDo Lite2 Bluetooth Gamepad
INSTRUCTION
Switch
- please ensure your Switch system and Lite SE are updated to the latest version
- NFC scanning, IR camera, HD rumble, and notification LED are not supported, nor can the system be wakened up wirelessly
- status LED can indicate up to 8 players
connection
Bluetooth connection
- turn the mode switch to S
- press home to turn on the controller, and the LED starts to rotate from left to right
- press the pair button for 3 seconds to enter its pairing mode. LED stops blinking for a short moment then starts to rotate again.(This is required for the very first time only)
- go to your Switch Home page to click on “Controllers”, then click on “Change grip/order” and wait for the connection
- LED becomes solid and the controller vibrates when the connection is successful
wired connection
- go to System Setting > Controller and Sensors > Turn on Pro Controller Wired Communication
- turn the mode switch to S
- connect the controllerto your Switch dock via a USB cable
- wait till the controller is successfully recognized by your Switch to play
Android
- please ensure your Android and Lite 2 are updated to the latest version
Bluetooth connection
- turn the mode switch to D
- press home to turn on the controller, LED 1 starts to blink
- press pair button for 3 seconds to enter its pairing mode. LED stops blinking for a short moment then starts to rotate again.(This is required for the very first time only) go to your Android device’s Bluetooth setting, and pair with [8BitDo Lite 2]
- LED becomes solid and the controller vibrates when a connection is successful
Wired Connection
- OTG support is required on your Android device. Please get in touch with your device manufacturer for more details
- turn the mode switch to D
- connect the controllerto your Android device via a USB cable
- wait till the controller is successfully recognized by your Android device to play
Turbo function
- hold the button you would like to set turbo to, then press the star button to activate/deactivate the function
- D-Pad, Left stick, Right stick, Home, Select, and Start buttons are not included
- turbo function is not available on Switch mode
battery
status —LED indicator
low battery: red LED blinks
charging: red LED stays solid
fully charged: red LED turns off
- About 20 hours of playtime with a 480mAh built-in battery pack, rechargeable with 1 hour charging time
- The controller will turn off for 1 minute with no connection and 15 minutes with a Bluetooth connection but no use controller stays on with the wired connection
support
please visit support.8bitdo.com for further
information & additional support
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>