Bona Service Kit for Edge UX 130 mm Instructions

Bona Service Kit for Edge UX 130 mm

HOW TO REPLACE THE COGGED BELT AND THE PULLEY

Tools you need: Wrench, Blocking tool, Philips Screwdriver, Allen Key, Hammer
Before starting, make sure that the machine is switched off and the power cord is disconnected from the socket.

• STEP 1
  Remove the plastic cap.

• STEP 2
  Turn the machine and remove the abrasive.

• STEP 3
  Remove the center screw.

• STEP 4
  Insert the blocking tool into the hole on the machine arm. Rotate the disc until the tool slides into place.

• STEP 5
  Hold the blocking tool steady while turning the sanding disc counter clockwise.

• STEP 6
  Remove the 6 screws from the bottom metal plate

• STEP 7
  Remove all screws from the Belt Protection plate.

• STEP 8
  Remove the blocking tool on the back side.

• STEP 9
  Rotate the pulley until you see the 3 screws.

• STEP 10
  Remove the 3 screws.

• STEP 11
  Remove the pulley by inserting the blocking tool into the hole on the machine arm and gently knock it with a hammer.

• STEP 12
  Replace the old belt with a new one.

• STEP 13
  Install the new pulley.

• STEP 14
  Make sure that you place the pulley in the right position by using the blocking tool to fixate it.

• STEP 15
  Rotate the pulley until you see the screw holes and put the screws back in place.

• STEP 16
  Insert the blocking tool into the hole on the ma-chine arm.

• STEP 17
  Put the Belt protection back.

• STEP 18
  Hold the blocking tool steady while screwing the sanding disc back in place.

• STEP 19
  Install the bottom plate.

• STEP 20
  Put the the center screw back.

• STEP 21
  Put the plastic cap back.

HOW TO ATTACH THE DUSTBAG

Tools you need: No tools needed
Before starting, make sure that the machine is switched off and the power cord disconnected from the socket.

• STEP 1
  Slide the dustbag over the tube.

• STEP 2
  Tie it to the tube using the strings on the dustbag.

HOW TO CHANGE THE VELCRO DISC

Tools you need: Heating gun, Knife, Pincers, White Spirit
Before starting, make sure that the machine is switched off and the power cord disconnected from the socket

• STEP 1
  Heat up the velcro for approx. 20 seconds.

• STEP 2
  Make a cut in the velcro

• STEP 3
  Remove the old velcro using a pincers

• STEP 4
  Clean the disc with White Spirit to remove the residuals.

• STEP 5
  Place the new velcro disc on the cleaned surface.

HOW TO CHANGE THE WHEEL

Tools you need: Pipe wrench, Allen key, Loctite
Before starting, make sure that the machine is switched off and the power cord disconnected from the socket

• STEP 1
  Loosen the bottom black handwheel.

• STEP 2
  Hold the top handwheel with a pipe wrench while removing the bottom screw using an Allen Key.

• STEP 3
  Remove the screw and nut from the old wheel and mount it on the new wheel.

• STEP 4
  Reinstall the new wheel and the bottom handwheel.

• STEP 5
  Use Loctite to secure the top handwheel.

• STEP 6
  Adjust the height of the wheel by adjusting the nut.

References

• Bring out the beauty in floors

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>