Bona Flexisand Service Kit Instruction Manual

SERVICE INSTRUCTIONS
Bona Service Kit for Bona Flexisand

https://www.bona.com/service-kit-flexisand

HOW TO REPLACE THE DUSTTUBE CLIP

Tools you need: Star Screwdriver, Torx 20
Before starting, make sure that the machine is switched off and the power cord disconnected from the socket.
STEP 1
Use a star srew driver to remove the two screws.

STEP 2
Remove the old dusttube clip.

STEP 3
Attach the new dusttube clip with the screws.

HOW TO REPLACE THE DUSTSKIRT

Tools you need: No tools needed

STEP 1
Pull the dust skirt over the machine and mount it in the intended notch on the rubber strip.

HOW TO REPLACE THE GAS SPRING

Tools you need: Wrench
Before starting, make sure that the machine is switched off and the power cord disconnected from the socket.

STEP 1
Remove the power cord from the socket

STEP 2
Loosen the nut on top of the gas spring

STEP 3
Loosen the sprint from the gas spring and pull it out. Tip the handle backwards.

STEP 4
Remove the gas spring by unscrewing it.

STEP 5
Install the new gas spring.

STEP 6
Watch this point while screwing the new gas spring. When the black rubber starts moving stop and turn the gas spring counter clockwise one rotation.

STEP 7
Tighten the nut.

STEP 8
Put the sprint back to secure the bottom part of the gas spring.

HOW TO REPLACE THE RUBBER BUMPER

Tools you need: Hammer, Scotch tape, Heating gun, Alcohol cleaner, Cartridge applicator
Before starting, make sure that the machine is switched off and the power cord disconnected from the socket.
STEP 1
Turn the machine over.

STEP 2
Remove the old bumper

STEP 3
Remove the old adhesive from the chassis

STEP 4
Clean the surface with an alcohol cleaner.

STEP 5
Prepare the new rubber bumper by heating it to hand warm

STEP 6
Apply 2K adhesive on the inside of the bumper using a cartridge applicator

STEP 7
Install the new rubber bumper starting at position 5 o’clock

STEP 8
Gently secure the position of the rubber bumper with a hammer.

STEP 9
Fixate the position of the rubber bumper for 30 min using scotch tape.

HOW TO REPLACE THE SUCTION PIPE

Tools you need: No tools needed
Before starting, make sure that the machine is switched off and the power cord disconnected from the socket.

STEP 1
Remove the old pipe

STEP 2
Install the new pipe with hose

STEP 3
Mount the extention pipe on the new hose

HOW TO REPLACE THE VELCROSTRIP

Tools you need: Star Screw Driver, Torx 20
Before starting, make sure that the machine is switched off and the power cord disconnected from the socket.

STEP 1
Remove the two screws

STEP 2
Remove the old velcro

STEP 3
Attach the new velcro with the screws

BONA SERVICE KIT – SERVICE INSTRUCTIONS

References

• Bring out the beauty in floors

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>