Shark SV75 Series Handheld Vacuum User Manual
- June 10, 2024
- Shark
Table of Contents
- Shark SV75 Series Handheld Vacuum User Manual
- IMPORTANT SAFETY INSTRUCTIONS
- FEATURES
- CHARGING YOUR HAND VACUUM
- MAXIMIZING THE LIFE OF YOUR NI-MH BATTERY
- ASSEMBLY OF THE HAND VACUUM
- USING THE CORDLESS VACUUM
- CHANGING & CLEANING THE DUST CUP FILTER
- BATTERY PACK REPLACEMENT & DISPOSAL
- TROUBLE SHOOTING
- PARTS
- DOWNLOAD
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Shark SV75 Series Handheld Vacuum User Manual
SV75 Series
Owner’s Guide
SV75_N 14; SV75Z_N 14; SV75SP_N 14
IMPORTANT : To register your Shark® Cordless Hand Vacuum, visit our website www.sharkclean.com.
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING YOUR CORDLESS HAND VACUUM
When using your hand vacuum, basic safety precautions should always be followed, including the following:
WARNING : TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY:
1. DO NOT use, charge or store the hand vacuum outdoors or on wet surfaces.
Store the cordless vacuum indoors. Put vacuum away after use to prevent
accidents.
2. Use only as described in this manual.
3. DO NOT allow to be used as a toy. Close attention is necessary when used
by or near children. DO NOT leave vacuum unattended while in use.
4. DO NOT handle plug, charger or appliance with wet hands.
5. Fully assemble hand vacuum before operating. DO NOT use hand vacuum
cleaner without dust cup filter in place. Use only on dry, indoor surfaces.
6. DO NOT use charger with an extension cord. Plug charger directly into an
electrical outlet. Use charger only in a standard electrical outlet.
7. DO NOT attempt to use the charger with any other product nor attempt to
charge this product with another charger. Use only the charger model
ZD6W210024US supplied with this appliance.
8. DO NOT use charger with damaged cord or plug. If charger or hand vacuum
has been dropped, damaged, left outdoors, or dropped in water, return it to
EURO-PRO Operating LLC for examination, repair or adjustment.
9. DO NOT abuse the charger cord, pull cord around sharp edges or corners or
close door on cord. Never carry the charger by the cord or yank to disconnect
from an outlet; instead grasp the plug and pull to disconnect. Keep charger
cord away from heated surfaces.
10. Use only manufacturer’s recommended attachments. Always turn off this
appliance before connecting or disconnecting the motorized nozzle. DO NOT
attempt to change accessories while unit is running.
11. Use extra care when cleaning on stairs.
12. Keep hair, loose clothing, fingers, and all parts of body away from
openings and moving parts.
13. DO NOT put any objects into openings. DO NOT use with any opening
blocked; keep free of dust, lint, hair and anything that may reduce air flow.
14. DO NOT use to pick up flammable or combustible liquids such as gasoline
or use in areas where they may be present. DO NOT pick up anything that is
burning or smoking, such as cigarettes, matches, or hot ashes.
15. This product includes rechargeable Nickel Metal Hydride batteries.
Batteries must be recycled or disposed of properly and safely. The battery
must be removed from the appliance before it is discarded. The appliance must
be disconnected from the supply when removing the battery. Do not incinerate
batteries or expose to high temperatures, as they may explode.
16. DO NOT charge the battery at temperature below 32°F (0°C). This will
degrade the battery performance, shorten life and cause gas leakage from
venting. Optimum charging efficiancy for the battery is within temperature
range of 50°F (10°C) and 86°F (30°C).
17 DO NOT charge with the battery polarity reversed. This will cause battery
venting, swelling or rupture.
18. Leaks from battery cells can occur under extreme conditions. Improper use
of the battery can cause the safety vent to activate. Small amounts of liquid
(alkaline electrolyte) will leak from the vent near the terminal. If the
liquid gets on the skin, wash immediately with soap and water. If the liquid
gets into the eyes, flush them immediately with clean water for a minimum of
10 minutes and seek medical attention.
19. DO NOT use for any purpose other than described in this user’s guide.
Look on your hand vacuum and follow all label and marking instructions.
20. This vacuum is intended for household use only.
21. DO NOT charge the unit outdoors.
SAVE THESE INSTRUCTIONS
FEATURES
1. Air-Intake Nozzle
2. Dust Cup Container
3. Dust Cup Filter
4. Dust Cup Release Button
5. Charging Indicator Light
6. On/Off Switch
7. Motor Housing
8. Charging Adapter
9. Motorized Brush
10. Crevice Tool
TECHNICAL SPECIFICATIONS: 15.6 Volt MAX** Ni-MH Battery dc
CHARGING YOUR HAND VACUUM
1. Before first using the hand vacuum, make sure that the On/Off switch is in
the “Off” position and charge until indicator light turns OFF, max. 6 hours.
2. Connect the charging jack to the charging hole that is on the back of the
vacuum.
3. Plug the charger into the wall outlet. The charging indicator light will
illuminate to show that the vacuum is being charged.
4. After first use, discharge the unit fully and then recharge until
indicator light turns OFF, max. 6 hours.
MAXIMIZING THE LIFE OF YOUR NI-MH BATTERY
5. Do not store in areas of high temperature or humidity.
6. Use only the charger supplied with the product. If other chargers are
used, the batteries can fail causing damage to the battery, product or
personal property.
7. After 3 months of non-use, the product should be fully discharged and then
recharged to maximize battery power.
8. If the product has never been used or has been stored for an extended
period of time without use – it will take several complete charge and
discharge cycles to realize the full operational time of your product.
9. Ni-MH batteries have a long useful life but at some time they will need to
be replaced.
To purchase replacement batteries, visit www.sharkclean.com.
ASSEMBLY OF THE HAND VACUUM
IMPORTANT : The dust cup filter must always be used when operating the hand vacuum.
10. Push the dust cup release button and remove the dust cup.
11. Verify that the dust cup filter is inside, then reattach the dust cup to
the hand vacuum.
12. The motorized brush can be used to vacuum short pile carpets or rugs. To
attach the motorized brush, make sure the On/Off switch is in the Off
position. Then firmly insert the motorized brush into the air-intake nozzle,
ensuring that the contact pins are engaged in the connector slots of the unit.
WARNING : Do not touch the motorized brush while it is in motion.
13. The crevice tool can be used to clean narrow, hard to reach places. To attach the crevice tool, push the attachment into the air-intake nozzle.
USING THE CORDLESS VACUUM
CAUTION : The air-intake nozzle and attachments must be free of obstructions at all times, otherwise the motor will overheat and could become damaged.
14. To start the vacuum, push the “On/Off” switch to the “On” position.
15. To turn the vacuum “Off”, push the “On/Off” switch to the “Off” position.
CHANGING & CLEANING THE DUST CUP FILTER
NOTE : It is recommended that the dust cup filter be replaced every 6 – 9 months to ensure peak performance of the vacuum.
16. Press the dust cup release button and pull out the dust cup.
17. Carefully remove the dust cup filter and empty the dust from the dust
cup.
18. Rinse the dust cup filter in cold water and let it dry completely before
replacing back into the dust cup. Do not wash it in a washing machine or use a
hair dryer to dry it.
Air dry only!
BATTERY PACK REPLACEMENT & DISPOSAL
The cordless hand vacuum is powered by Ni-MH batteries, which must be recycled or disposed of properly in accordance with state, federal and local laws. If uncertain as to how to remove the battery pack, we suggest that you take your hand vacuum to a reputable small appliance service technician to have this service performed. Do not attempt to replace the batteries used in this product with any other type of battery. Follow these steps when replacement of the battery pack is required:
19. Using a #1 Phillips head screwdriver, remove the single screw securing
the battery compartment cover located underneath the unit.
20. To remove the cover, lift up the battery compartment cover. Never open
the battery compartment except to replace the battery pack. Set the cover and
the screw aside.
21. Slide the battery strap over and lift it out.
22. Carefully lift out the top battery pack and disconnect the terminals.
23. Connect the terminals to the new battery and insert into the battery
compartment;
taking care to connect the black lead (-) to the negative connector first and
the red lead (+) to the positive connector second and insert into the battery
compartment.
Take care to tuck the wiring completely in so that the wiring does not
interfere with the battery compartment cover when it is replaced.
24. Replace the battery strap, the battery compartment cover and the screw
making sure not to over-tighten the screw.
WARNING : Never use ordinary batteries for replacement as these may leak and damage your vacuum cleaner. Use only the battery pack XB75N provided by EURO-PRO Operating LLC for replacement. Call customer service at 1800-798-7398 or visit our web site at www.sharkclean.com to order replacement battery packs.
CAUTION:
- Use only with battery pack supplied.
- Do not attempt to remove the battery pack from the unit to charge.
- Never throw the battery pack or the appliance into a fire or incinerate it.
- Do not remove or damage the battery casing.
- Do not place the batteries on metal surfaces.
- Do not touch metal parts of the batteries together as the batteries will overheat.
TROUBLE SHOOTING
The hand vacuum will not operate| Batteries need to be recharged.
Batteries are dead and need to be replaced.
There is no power in the electrical outlet being used while charging. Try to
charge using a different electrical outlet.
---|---
Motorized brush will not work| The metal contact pins on the motorized brush
are not in contact with the connector slots on the vacuum. Remove the
motorized brush and re-insert firmly into the air-intake nozzle.
The motorized brush is blocked. Carefully remove all the lint, hair, etc. from
the motorized brush.
Hand vacuum will not pick up or suction is weak| Dust cup is full. Empty the
dust cup.
Dust cup filter needs cleaning or replacement. Clean or replace the dust cup
filter.
Vacuum needs to be recharged.
Dust is escaping from the hand vacuum| Empty the dust cup container.
The dust cup filter is not installed correctly. Remove it and re-insert it.
The dust cup filter has a hole or a puncture in it. Replace it with a new one.
PARTS
To order additional parts for your Shark® CORDLESS HAND VACUUM models SV75_N
14, SV75Z_N 14, SV75SP_N 14 go to
www.sharkclean.com
or call 1-800-798-7398.
PART | PART NO |
---|---|
Dust Cup Filter | XSB726N |
Battery Pack | XB75N |
Charging Stand (optional) | 1048FI |
Charging Adapter | XA75N |
Copyright © EURO-PRO Operating LLC, 2013
Boston, MA 02459 / Ville St. Laurent, Québec H4S 1A7
1-800-798-7398
www.sharkclean.com
Printed in China
Illustrations may differ with actual product.
SV75_N series.ES.140703_2
DOWNLOAD
Shark SV75 Series Handheld Vacuum:
Owner’s Guide – [Download PDF]
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>