OneNet 5862 Mesh Wi-Fi Node User Guide
- June 5, 2024
- OneNet
Table of Contents
5862 Mesh Wi-Fi Node
**User Guide
**
Thank you for choosing the OneNetTM Node
Set-up in step
OneNetTM
MESH WIFI Node
Set-up Guide
After you install the OneNetTM Wi-Fi router, you will only need to plug in the
OneNetTM nodes and the mesh system will be created automatically.
After the mesh system is created successfully, the OneNetTM node’s indicator
light will turn green and stop blinking.
If the OneNetTM node’s indicator light blinks, it means that the signal is
weak. Please move the OneNetTM node closer to the other nodes (Nodes or
Routers) in the mesh network.
If the OneNetTM node fails to connect to the mesh system or there is no
internet, the indicator light will be red and steady. Please check the network
status of the OneNetTM host router or shorten the distance between the
OneNetTM node and the other OneNetTM nodes (Nodes or Routers)
Download the OneNetTM app
Control your mesh network from anywhere, anytime
Android users please download the application form:
www.investor.tv/support or scan the QR code
below.
iOS users
The application will be available soon.
Need help?
**** If you want to connect the OneNetTM node to a different OneNetTM router,
from a separate package, please follow the instructions from the link below:
www. investor.tv/support
FCC ID: APR-BEE
This device complies with Part of the FCC rules. Operation is subjected to the
following two conditions: () this device may not cause harmful interference,
and () this device must accept any interference received, including
interference that may cause undesired operation. Changes or modifications not
expressly approved by the party responsible for compliance could void your
authority to operate the equipment.
The device for operation in the band – MHz is only for indoor use to reduce
the potential for harmful interference to co-channel mobile satellite systems;
This device complies with Industry Canada’s license-exempt RSS. Operation is
subject to the following two conditions: (1) This device may not cause
interference; and (2) This device must accept any interference, including
interference that may cause undesired operation of the device. The distance
between user and products should be no less than cm.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
You need a working OneNet TM router to use the OneNet TM mesh node.
Need help setting up your OneNetTM router?
Please scan this QR code: Or visit:
www.investor.tv/support
www.investor.tv
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>