wayfair Outdoor LED 192 Inch Under Cabinet Tape Light Instruction Manual
- June 3, 2024
- wayfair
Table of Contents
wayfair Outdoor LED 192 Inch Under Cabinet Tape Light
INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT: Read before installing fixture. Retain for future reference.
WARNING: Risk of Fire or Electric Shock
- Installation requires knowledge of luminaries electrical systems. If not qualified, do not attempt installation. Contact a qualified electrician.
- To reduce risk of fire and over-heating, secure all connections.
- TURN OFF the electrical power before proceeding.
- The electrical rating of this product is 120V/60Hz.
- The grounding and banding of the overall system shall be done in accordance with National Electric Code (NEC) Article 600 and local codes.
- To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
- Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
- This device is not intended for use with emergency exits.
- Suitable for wet locations.
NOTE: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference; (2) This device must accept any interference received, including interference that may cause undesired operation.
TOOLS REQUIRED
Pencil and screw driver required.
INSTALLATION
Before installation, select a location where you want to install, measure the
required length of strip light, and mark it. Confirm that the adapter power
cord will reach the desired power outlet and the LED strip light. Clean the
mounting surface and keep it dry. It is important that the surface is smooth
and clean before mounting the fixture.
S TEP 1: Turn power OFF before installing fixture.
STEP 2: Find the desired place for the strip light and mark it clearly
using the provided clips. Mount the fixture using the provided screws.
STEP 3: If there is an LED chip in a corner when placing the strip light,
ensure the angle of the bend is greater than 90º to avoid damaging the LED
chip.
STEP 4: Plug strip light into the nearest outlet. Installation is
complete. Turn power ON.
STEP 5: Via the control button on the driver, toggle through the
functions:
- Warm White ON · Cool White ON
- Warm and Cool White ON
- RGB ON
- OFF
- Press and hold on for 5 seconds to connect APP
STEP 6: App Connection: To connect your device, download the free “Starfish Smart Lighting” App from the app store. Please refer to our Starfish User Guide for detailed instructions on how to pair your device.