Wayfair Canada LED Flush Mount Light Instruction Manual
- June 4, 2024
- Wayfair Canada
Table of Contents
LED Flush Mount Light
Instruction Manual
LED Flush Mount Light
BLINK™ – Edge-lit LED fixture series With Integrated Dimmable Driver
Thank you for purchasing our product. This fixture has been manufactured from
components with advanced optoelectronics to ensure high reliability and long
life.
Before assembling please read this Operation Manual carefully and save it in a
safe place for future reference.
Please note that all electrical connections must be in accordance with local
and National Electrical Code standards as well as local building codes. In
case you are not familiar with proper wiring connections and building codes,
consult a qualified electrician.
- RISK OF ELECTRIC SHOCK – THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH APPLICABLE INSTALLATION CODES BY A PERSON FAMILIAR WITH MENTIONED ABOVE CODES AND THE HAZARDS INVOLVED. DISCONNECT POWER AT THE CIRCUIT BREAKER OR FUSE BEFORE INSTALLING OR SERVICING.
- BEFORE USE OF THE PRODUCT CAREFULLY READ THE WHOLE INSTALLATION INSTRUCTIONS.
- THE PRODUCT IS SUITABLE FOR BOTH: DAMP AND WET LOCATIONS.
- ASSEMBLE THE PRODUCT ONLY WITH THE USE OF THE PARTS PROVIDED AND THE HOUSING;
- IMPROPER ASSEMBLY MAY RESULT IN THE DEVICE FAILING WHICH COULD DAMAGE THE PRODUCT, OR PERSONAL PROPERTY OR CAUSE INJURY.
- ASSEMBLY SHALL FOLLOW WITH ACCESSORIES DELIVERED WITH THE SET ONLY. THE DEVICE IS NOT A TOY, KEEP OUT OF REACH OF CHILDREN.
Specifications:
Flush Mount Light
Operating Voltage: 120V
Dimming: LED-rated Controls
Power consumption: 10.5W/13.5W/18.5W
STEP 1: Turn off/disconnect power at the circuit breaker. Attach connector (provided) to AC cable from junction box: L side to Black side wire. N side to White AC wire. STEP 2: Attach the bracket to the junction box using 2 screws (provided). Pull the AC cable with the connector through the bracket center hole. STEP 3: Make a ground connection. Next simply “snap” the two sides of the orange wire connector together. STEP 4: Carefully push connections back into the 1-Box, Align the two clips and driver on the fixture body to the opening of the 1-Box Mounting bracket. STEP 5: Push and feed all wires up into the junction box as you raise the fixture into place. Push to lock the fixture in place. For wet location usage, please caulk the edge of the fixture with glue to the ceiling.
Installed-Congratulations…
Enjoy the light!
Dimming This
product is compatible with most LED-rated type dimmers available on the
market. The dimming performance will depend on the kind of dimmer and dimmer
settings. Visit Satco.com for an up-to-date list of compatible dimmers.
Cleaning
- Clean with a soft or damp cloth. While cleaning with a damp cloth making sure the power is off.
- Do not clean with abrasives.
5-Year limited warranty
The purchased product is covered with a 5-year warranty in respect of any defect in material or workmanship after the purchase date. Satco shall bear no responsibility on account of the guarantee, as well as shall bear no liability for any faults, in case of improper operation, use negligence, accident or exposure to natural hazard, or excessive use over the limits specified for the unit, or if any unauthorized alteration or repair followed.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>