LOCKER DOWN LD2013 Console Safe Toyota Instruction Manual
- June 3, 2024
- LOCKER DOWN
Table of Contents
LD2013/LD2013EX Console Safe Toyota
Instruction Manual
[2007-2013 Toyota Tundra]
LD2013 Console Safe Toyota
-
For any combination style lock, it is a good idea to set the combination before installing the safe. We recommend that the combination be set with the DOOR OPEN in order to test the lock combination effectively without locking yourself out.
-
Clear out the contents of the center console for now, including the factory mat at the bottom of the console.
-
Remove the LEFT FRONT and RIGHT REAR bolts in the bottom of the center console compartment.
-
Remove the neoprene padding from the bottom of the inside of the safe.
-
Set the safe into the center console.
a. To ensure that the safe is set into the console properly, make sure that the two slots at the bottom of the safe LINE UP with the two factory bolt threads where the bolts were removed from in step 3. -
Using your 10mm fastening device, insert the LOCK’ER DOWN PROVIDED 10MM BOLTS into the factory holes at the bottom of the safe (these holes should line up with the factory screw holes at the bottom of the compartment)
a. The LONGER 10mm bolt should be screwed into the right rear bolt thread, and the SHORTER 10mm bolt should be screwed into the left front bolt thread.
b. Make sure that the included washers are fit BETWEEN the bolts and the safe! -
Tighten the bolts, DO NOT OVER TIGHTEN, THIS COULD DAMAGE THE CONSOLE.
-
Re-insert the neoprene padding that was removed from the safe before installation.
-
Enjoy your purchase!
Tools Needed:
- IMPACT DRILL or SOCKET WRENCH
- 10mm Socket bit
Contents Included:
1 Longer 8mm bolt with 10mm head.
1 Shorter 8mm bolt with 10mm head.
2 Washers
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>