RIGHT WEIGH 201-EBT-20B-WB Gauge and Mounting Bracket Installation Guide
- June 3, 2024
- Right Weigh
Table of Contents
RIGHT WEIGH
201-EBT-20B-WB Gauge and Mounting Bracket
Installation Guide
201-EBT-20B-WB Gauge and Mounting Bracket
INSTALLATION OVERVIEW
201-EBT-20B-WB
This installation overview is not a substitute for reading the product
manuals
WHAT’S INCLUDED
| 1 x 201-217-30 – Gauge and mounting bracket
---|---
| 2 x 218-SK – Weld strain sensor installation kit
SENSOR CONFIGURATION
The gauge should be set to detect 2 Spring Sensors. See Spring Suspension Gauge manual for more information on how to set the sensor configuration.
APPLICATIONS
Straight Truck: Walking Beam Spring Suspension (DRIVE AXLE GROUP ONLY)
Sensor Location:
The strain sensors should be mounted on the back left and the front right of
the walking beam drive axle group. Make sure they are installed on the top of
the beams. See the 218-SK manual for more information on how to install the
strain sensors.
Mode:
Set the gauge to Average (AVG) mode to see a single weight for the drive axle
group. See Spring Suspension Gauge manual for information on how to set the
mode.
Scan here to see additional resources on our website including full
installation manuals, quick set up guides, and video tutorials!
CONTACT US!
Right Weigh, Inc.
888-818-2058
www.rwls.com
support@rwls.com
Follow Us!
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>