ZINC Urban 320 Pro Big Wheeled Folding Scooter User Manual
- June 3, 2024
- zinc
Table of Contents
Urban 320 Pro Big Wheeled Folding Scooter
User Manual
BIG WHEELED
FOLDING SCOOTER
URBAN 230 PRO
Urban 320 Pro Big Wheeled Folding Scooter
Included: -Allen Key
WARRANTY
SO THAT YOUR WARRANTY IS VALID PLEASE REGISTER AT
WWW.ZINCSPORTS.COM WITHIN 30 DAYS OF RECEIVING
THE PRODUCT.
UNFOLDING / FOLDING THE SCOOTER
TO UNFOLD
Pull the folding mechanism up, then lift the steering column up unti I it
reaches the vertical position. You will hear a ‘click’ as it locks into place.
TO FOLD UP
Pull the folding mechanism up, then pull the steering column down until it
reaches the horizontal position. You will hear a ‘click’ as it locks into
place. 
ADJUSTING THE HEIGHT
To adjust the height of the handlebar pull open the clamp, push the spring
button in, and move the handlebar to the desired height. Once the spring
button clicks into the slot then close the clamp.
The degree of tension of the quick-release lever can be adjusted by
tightening or loosening the screw. Be careful not to over-tighten, so that you
can always open and close the clamp by hand. When you release the quick-
release lever, the handlebar should move freely (after pressing the spring
button).
ASSEMBLING THE HANDLEBAR GRIPS
TO ASSEMBLE
- Lift the handlebar clip upwards.
- Pressing in the spring button on handle, and insert the handlebar grips into position.
Insert both handlebar grips inside and then close the handlebar clip to secure it.
TO DISMANTLE
Reverse the process by opening the handlebar clip, remove the handlebar grips
and secure it in the handle holder. 
TO UNFOLD/ FOLD THE KICKSTAND
TO UNFOLD THE KICKSTAND
Stop and dismount the scooter. Kick out the stand from under the
scooter.
TO FOLD AWAY THE KICKSTAND
Fold the kickstand back up under the footplate before you climb on and ride
away. 
TO USE Ensure the rider understands how to
ride the scooter.
- Grip the handlebar with your hands, place one foot on the deck and the other foot on the ground.
- Pay attention to your surroundings and make sure that your riding area is clear.
- Kick backwards with your foot beside the scooter to give you motion.
- Repeat this kicking action in order to stay in motion.
- To stop or slow down, press the brake lever and place your kicking foot on the brake pedal above the rear wheel or put your kicking foot on the ground.
- Do not over-steer as this could cause you to fall from the scooter.
IMPORTANT SAFETY INFORMATION
Ensure the rider understands the safety information.
- Always wear protective equipment such as helmet, gloves, elbow and knee pads. Also long sleeved shirts and long trousers help protect skin.
- Always wear fully enclosed shoes with the laces tightened securely and tucked into your shoes.
- All bolts, wheels and handlebars should be checked and tightened before and after every use.
- This scooter should only be ridden on dry, flat, level ground. Do not use the scooter on uneven, wet ground, on rocks or gravel. Do not use at dusk or night.
- Wet weather reduces traction, braking and visibility.
- Excessive use of the brake will cause heat to generate which can damage the wheel and can cause brake failure. Allow brake and wheels to cool if used continuously. Do not touch brake if hot as it may cause harm.
- All children and preteens should ride with adult supervision at all times. The supervisor should check all fasteners, wheels and handlebars and tighten before and after every use. In addition the supervisor should ensure the rider is wearing all appropriate safety equipment.
- All local traffic and scooter riding laws and regulations must be followed at all times. Stay away from roads and highways, cars and pedestrians and respect other pavement users.
- Adult supervision is required during the initial assembly and maintenance procedures due to the risk of finger entrapment. Keep fingers away from moving parts, injury may occur.
MAINTENANCE By an adult
- Please rotate the bearings and wheels to check if they are rolling smoothly.
- It is suggested to disassemble, clean, and add lubricant every 6 months paying extra attention to the moving parts, clearing them of grit and dirt so they move freely. Please make sure the parts specifications are correct with the dealers if some parts need to be replaced.
- Do not leave this product in high temperature, intense sunlight or dusty areas. Store in a dry place.
- Do not make any modifications to this product. Any modifications made to this scooter will make your consumer rights null and void.
- Self-locking nuts and other self-locking fixings may lose their effectiveness over time. If any of these components are no longer functioning how they should, it is strongly recommended that you discontinue use of the product and seek replacement parts from the dealer or importer of this product.
- Wipe with a damp cloth to remove dirt and dust. Do not use industrial cleaners as they may damage the surfaces. Do not use alcohol, alcohol-based or ammonia-based cleaners as they may damage or dissolve some components or soften the decals or the grip surface adhesive.
- The wheels and wheel bearings can become worn after regular use and can be replaced easily. Remove the axle bolts with two Allen keys and slide the wheel off its fork. Replace with the new item, screw in the bolt through the aligned fork and wheel then tighten with an Allen key on either side and tighten securely.
Using a 5mm Allen key, regularly make sure
that the ring clamp at the base of the handlebar is securely tightened, should
it become loose through general use.
WARNING
- Protective equipment should be worn. Not to be used in traffic. 100kg max.
- The scooter should be used with caution, since it requires great skill, so as to avoid falls or collisions causing injury to the user and the third parties.
- Do not take this scooter on the road or public highway.
- Please ensure that all locking devices are engaged.
Complies with BS EN 14619:2019 / EN14619:2019. Maximum weight 100kg for Class
A.
Keep the instruction since it contains important information.
WARRANTY
Zinc Sports IM non-electric scooter warranty
Thank you for purchasing a Zinc Scooter and we hope that you enjoy using it.
Please ensure that you read the fol lowing warranty.
In order for your warranty to be valid you must satisfy the following
conditions.
- All products must be registered at www.zincsports.com within 30 days of receiving the product for the warranty to be valid.
- Proof of purchase is also required for your warranty to be valid.
- You must be the original purchaser who bought the product from an authorised dealer, your warranty cannot be transferred.
- You must report any defects to Zinc Sports within 30 days of discovery of said defect else the warranty will not be valid.
Failure to follow the conditions highlighted above means that your warranty
will be void. We recommend that you save your original sales receipt.
The warranty lasts 1 year from the date of purchase.
The warranty covers any manufacturing defects in materials or workmanship when
used under normal use conditions and in comp I iance with the stipulations in
the instruction manual and warranty guidelines.
The warranty does not cover wear, and tear or parts deemed to be wearing parts
such as but not limited to bearings, brakes, wheels, grip tape or folding
mechanisms. The warranty does not cover cosmetic parts, or parts deemed as
cosmetic parts such as but not limited to paint, stickers and labels. The
warranty does not cover loss of parts. Spare parts may be avai I able for
purchase from Zinc Sports if you are not covered by the warranty.
Under no circumstance will Zinc Sports be obliged to provide compensation for
bodily injuries, death, property damages, losses, hindrance of profits,
prevention of use or any other damage that will be caused directly or
indirectly as a result of usage of this device. Zinc Sports advise that you
contact your insurance company to determine whether coverage is provided for
the use of this scooter, or to take out a new policy.
For the full warranty policy please visit our website at www.zincsports.com
PRODUCT CODE: ZC08513 ZINC BIG WHEELED FOLDING URBAN 230 PRO SCOOTER – RED
CUSTOMER HELPLINE
Hy-Pro advise you to contact us directly and not to return this item to the
place of purchase. Hy-Pro has taken great care to ensure this item
has reached you in good condition, should you have a query please ring our
helpline +44 (0) 800 731 0006 where your call will be dealt with promptly.
Alternatively please contact us on email:
customerservices@zinchq.com
Hy-Pro International: Hy-Pro House,
Centrus Park, Arenson Way, Dunstable,
Bedfordshire LU5 5BN. UK.
Hy-Pro Asia
Room 1011, 10/F, Peninsula Centre,
67 Mody Road, Kowloon, Hong Kong.
Hy-Pro Europe
Cube Building, Monahan Road,
Cork, T12H1XY, Republic Of Ireland.
Customer Care Line
Tel: +44 (0) 800 731 0006
wwww.hy-pro.co.uk
www.zincsports.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>