scs sentinel SAL0064 Standalone Alarm Installation Guide
- September 24, 2024
- SCS sentinel
Table of Contents
scs sentinel SAL0064 Standalone Alarm
INSTALLATION
ALARM
OPENING SENSOR
REMOTE CONTROL
USE
AWAY Mode (total)
Slide the button on the re- mote control to AWAY mode and press the ON button. The alarm will beep. After 30 seconds, the unit goes into ar- med mode. The alarm will sound and a light will flash if:
– the opening detector opens
– the motion detector detects a passage.
To disarm the alarm, press OFF on the remote control. The alarm goes off and beeps twice.
HOME mode (partial)
Slide the button on the remote control to HOME mode and press the ON button. In HOME mode, you only use the opening sensor. The mo- tion detector is deactivated in this mode. Your window or door is therefore protected by the opening sensor. If a door or window is opened, the alarm is triggered. To disarm the alarm, press the OFF but- ton on the remote control.
REPROGRAMMING (IF NECESSARY)
RESET
Press and hold the button on the back of the alarm while inserting the batteries. 2 beeps will sound, all items are deleted.
Maximum transmitted power > 20 mW
Frequency 433.92 MHz+/- l00kHz
Power supply 3 x LR06 (1,5 V)
Remote control 1 x CR2032 (3V)
Opening detector 1x CR2032 (3V)
For an individual answer, use our online chat on our website www.scs- sentinel.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>