EXTRALITE HyperLefty 3 MTB Lefty Front Hub Instructions

: June 3, 2024
: EXTRALITE

Table of Contents

Product Descriptions
- Features
Extralite Limited Warranty
Support
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

EXTRALITE HyperLefty 3 MTB Lefty Front Hub Instructions

Product Descriptions

Product Overview

Features

Destination: X-Country, Enduro use.
Compatibility: Lefty 2 forks.

Lacing
See www.extralite.com HyperLefty3 page for hub dimensions and spoke length calculation. Insert spokes respecting spoke head fittings countersink on hub and lace.

Maximum spoke tension
Disc side 110kgf +/- 10kgf
Right side 110kgf +/- 10kgf

Hub set-up
Slightly grease and install Seal-Protector between left bearing and disc. Install disc rotor.
Secure rotor bolts with mild threadlock (Loctite 243) at 6Nm.

Installation
Insert hub trough axle and tighten Axle-Bolt clockwise at 10Nm.

Removal
Unscrew Axle-Bolt, Locking-Ring will work as extractor.

Front hub Maintenance.
Clean hubs externally with warm water and soap.
Never use high-pressure spray washing directly on bearings.

Warning
Bearing axial tolerance is factory matched. Do not remove or flip bearings. This will reduce bearing life or result in play at the rim.

Water / moisture inside hub can seriously damage bearings in few weeks

Extralite Limited Warranty

Extralite products are warranted against defects in materials and/or workmanship for a period of two years from original date of purchase to the original owner only.
Any Extralite product that is returned and found by Studio Riva to be defective in materials and/or workmanship will be repaired or replaced at the sole discretion of Studio Riva. This warranty is the sole and exclusive remedy. Studio Riva shall not be held liable for any indirect, special or consequential damages. The warranty is expressly limited to repair or replacement of the product that has been returned and found to be defective by Studio Riva and are the sole remedy of the warranty.
No credits or refunds will be issued.
The warranty does not cover: normal wear, tear and fatigue; damage or failure due to accident or collision. Improper assembling, poor maintenance, alterations or modifications, installation of parts not compatible with Extralite products void this warranty. Warranty does not cover damage arising from crash, abuse and/or misuse or any other circumstances in which the product had been subjected to forces or loads beyond its design. Immediatly replace the component after crash and violent shock, or after continuos heavy use.
Improper use, modification and/or part changing, including surface finishing, could irreparably damage the component. All labor charges for warranty service are responsibility of the product owner.

INSTALLATION WARNING:
Extralite components are extremely performing and lightweight, crafted with very high quality, they request adequate installation and maintenance care. We strongly recommended that a professional bike shop install and service your Extralite components.
Improper assembly and/or adjustment may significantly compromise strength and durability of the component causing serious personal injury. Carefully check proper tightening torque of every bolt. Always respect installation recommendations. Extralite components are designed for a specific use X-Country or Road or Downhill, respect product specific destination.
Note: the rider assumes all the risks regarding use and installation of Extralite components.