HDWR GLOBAL CR200WG Mid Range Access Control RFID Reader User Manual
- September 16, 2024
- HDWR Global
Table of Contents
HDWR GLOBAL CR200WG Mid Range Access Control RFID Reader
Frequently Asked Questions
Q: What is the recommended power supply voltage for the SecureEntry- CR200WG?
A: The recommended power supply voltage is DC 9V – 16V.
Q: What type of cable is recommended for connecting the reader with the controller?
A: We recommend using an 8-wire twisted pair cable. For Data1Data0 cable, a twisted pair cable with a cross-sectional area of at least 0.22 square millimeters is suggested.
Q: What is the maximum cable length supported for connecting the reader with the controller?
A: The maximum recommended cable length is 100 meters.
Specifications
- Warranty: 1 year
- Device Type: Medium Range RFID Reader for Access Control
- Color: dark grey
- Verification Type: RFID Card
- Operating frequency: 125 kHz
- Reading range: 80 – 100 cm
- Voltage: DC 12V
- Working Current: ≤100mA
- Type of Chips Read: EM
- Interface: Wiegand 34
- Communication Distance: ≤100m
- Operating temperature: -10°C – 70°C
- Product dimensions: 26 x 26 x 3.5 cm
- Package dimensions: 28.3 x 26.6 x 4.6 cm
- Product weight: 2 kg
- Weight with packaging: 4 kg
Set contents
RFID access control reader with cable
Features
- The medium-range reader allows you to read data from an RFID card from a distance of 80 cm to even 1 meter
- Wiegand 34 interface allows you to connect to a variety of devices
- The RFID reader is ideal for the entrance to the building as an access device
Installation
Use a Phillips-type screwdriver to loosen the screw between the panel and the motherboard. Next, attach the motherboard to the sidewall with a plastic plug and screws.
Connection diagram
| Wiegand 26/34 | RS485 | RS232 |
|---|---|---|
| Red | DC 9V – |
16V
| Red| DC 9V –
16V
| Red| DC 9V –
16V
Black| GND| Black| GND| Black| GND
Green| D0| Green| 4R+| |
White| D1| White| 4R-| White| TX
Blue| LED| | | |
Yellow| BEEP| | | |
Grey| 26/34| | | |
Orange| Bell| | | |
Brown| Bell| | | |
Comments
- Check the electrical voltage (DC 9V – 16V) and distinguish the positive anode and cathode of the power supply.
- When external power is used, we suggest using the same GND power supply with the controller panel.
- The cable connects the reader with the controller, we recommend using 8-wire twisted pair cable. The Data1Data0 data cable is twisted pair cable, we suggest that the cross-sectional area should be at least 0.22 square millimeters. The length should not exceed 100 meters. Shielded wire connects GND, and two-core cable will improve the reader’s working efficiency (or the use of a multi-core AVAYA cable).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>