INNOKIN KLYPSE PRO Vape Pod User Guide

Table of Contents

POD

MOD

Fill the pod
- Pull the tab to open
- Add E-Liquid carefully
- Push the tab to securely close
- Important
- Wait for at least five minutes after filling to allow the new pod to saturate with E-liquid.
- Keep the pod from going completely empty of E-liquid.
- Refill it regularly to avoid dry hits or coil damage.
Install the Pod
- Simply insert the magnetic pod into the mod.

Press the power button three times within two seconds to turn the device on or off.
When the device is powered on, the indicator light flashes red, yellow, and green sequentially, while the PMOLED display shows the device’s wattage and battery level.
When the device is powered off, the indicator light of the current battery level flashes twice, while the PMOLED display shows “OFF”.

Puff Time

While vaping, the duration of your current draw will be displayed in seconds, and the indicator light for your current battery level will immediately flash.

Adjust the Wattage

Double-click the power button to enter adjustment mode. When the power value flashes, click the power button to select the upward wattage value; it will loop from maximum to minimum.
Press and hold the button again to enter the quick adjustment mode.
Wait for five seconds to exit the wattage setting.

Charging

Charge promptly based on battery level. Do not allow the battery to stay under 10% or above 90% for extended periods.
Use a standard output charger and charging cable with the correct charging current and voltage range.
Charging pauses while vaping and resumes when vaping stops.

Caution

Turn the device off when not in use to avoid depleting the battery and minimize excess battery wear.
Avoid dropping, throwing, or mishandling the device to prevent damage.
Protect the device from direct sunlight, dust, moisture, or mechanical shock.
Keep the device away from any water, liquid, or flammable gas.
Keep the contents of this package out of reach of children, non-smokers and animals.
Do not leave the device charging while unattended.
Do not use it if pregnant or breastfeeding.
Warning: Do not use this product if you suffer from heart disease, severe hypertension, diabetes, stomach ulcers or have a history of seizures.

EEE Recycling

This product is meant to be disposed of in an approved e-waste receptacle or recycling bin. Do not throw it away in standard waste receptacles.

Low battery alarm
- When vaping with a low battery, the device will switch off the output, while the indicator light flashes red 8 times and the PMOLED Display shows ” “
- No Load / High Resistance Protection When no load resistance or high resistance is detected, the device will switch off the output, and the indicator light will turn green and flash until vaping stops. Simultaneously, the PMOLED Display will show “ “
- Short Circuit Protection
- When vaping with low resistance or short circuit, the device will switch off the output and the indicator light will flash red for 5 seconds. Simultaneously, the PMOLED Display will show “ “
- Auto-Shut Off Protection
- When vaping more than 10 seconds in one breath, the device will switch off the output and the indicator light for the current battery level will flash 10 times. Simultaneously, the PMOLED Display will show “ “
- Overheat Protection
- When the PCBA (Printed Circuit Board Assembly) temperature sensor detects a high temperature, the device will switch off the output and the indicator light will flash red 3 times. Simultaneously, the PMOLED Display will show “ “