REZNOR VZ,VZH Gas Fired Low Intensity Radiant Tube Heaters Installation Guide
- September 11, 2024
- Reznor
Table of Contents
REZNOR VZ, VZH Gas Fired Low-Intensity Radiant Tube Heaters
Product Information
Specifications
- Model : Reflector Side Extension Kit CD28
- Compatibility : Models VZ and VZH Gas-Fired Low-Intensity Radiant Tube Heaters
- Kit Components:
- Support bracket, reflector side extension (PN 01329911) – Quantity: 2
- Reflector side extension, 96-inch (244 cm) (PN 01368000) – Quantity: 1
- Retainer clip (PN 02751200) – Quantity: 2
- Sheet metal screws (PN 94118106) – Quantity: 2
Product Usage Instructions
- Install Support Brackets:
- Position the support brackets (1) as shown in Figure 1.
- Tighten the wingnut on each bracket to secure it to the tube.
- Cut Notches in Reflector Side Extension:
- As necessary, cut notch(es) in the reflector side extension (2) for clearance of suspension hardware as shown in Figure 1.
- Secure Reflector Side Extension:
- Slide the bottom of the reflector side extension (2) through the support brackets (1).
- Secure the retainer clips (3) at the top of the side extension to the reflector using sheet metal screws (4).
OPTION CD28 FOR MODELS VZ AND VZH
NOTE : If the installation requires side extensions to reflect heat in a desired direction, refer to these instructions along with the installation manual provided with the heater for complete heater installation instructions.
- Refer to the installation manual provided with the unit for important safety information.
- Ensure that all components shown in Figure 1 and listed in Table 1 are available before beginning installation.
Table 1. Reflector Side Extension Kit (PN 02712700) Components
Item No.| Component| PN (Quantity)
1| Support bracket, reflector side extension| 01329911 (2)
2| Reflector side extension, 96-inch (244 cm)| 01368000 (1)
3| Retainer clip| 02751200 (2)
4| Sheet metal screw, #8 × 3/8| 94118106 (2)
Quantity is two (2) per side extension. Use additional support brackets
as necessary for installation locations with high air movement.
- Install support brackets (1) as shown in Figure 1 and tighten wingnut on each bracket to secure bracket to tube.
- Cut notch(es) as necessary in reflector side extension (2) as shown in Figure 1 to provide clearance for suspension hardware.
- Slide bottom of reflector side extension (2) through support brackets (1) as shown in Figure 1 and secure retainer clips (3) at top of side extension to reflector using sheet metal screws (4).
Specifications and illustrations subject to change without notice or incurring obligations. Latest version of this manual is available at www.reznorhvac.com.
SCAN THE QR CODE
©2024 Nortek Global HVAC LLC, O’Fallon, MO. All rights reserved. VZ-VZH-CD28 (06-24) 1047440-0
DO NOT DESTROY. PLEASE READ CAREFULLY. KEEP IN A SAFE PLACE FOR FUTURE REFERENCE.
FAQ
Q: Can I install the reflector side extension kit on any type of heater?
A: No, the CD28 kit is specifically designed for use with Models VZ and VZH
Gas-Fired Low-Intensity Radiant Tube Heaters.
Q: Do I need additional support brackets for installation?
A: Additional support brackets should be used in locations with high air
movement to ensure proper installation stability.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>