SECRUI KIF81H DO-CE-WDB1R1CAA-x Wireless Doorbell with 2 Receiver User Manual
- June 3, 2024
- secrui
Table of Contents
SECRUI KIF81H DO-CE-WDB1R1CAA-x Wireless Doorbell with 2 Receiver
TABLE OF CONTENT
- Package contents
- Safety instructions
- Installing and using the device
- Cleaning and maintenance
- Technical specifications
- Storage and transportation
PACKAGE CONTENT
SAFETY INSTRUCTIONS
The following basic precautions must always be taken before using the
“Wireless Doorbell” hereinafter referred to as ‘device’:
General information
- Read the instructions for use carefully and keep them safe. If you give this device to other people, please also pass on this manual.
- Only use this device in accordance with the instructions in this user manual.
- The device is not a toy. Keep it out of the reach of children and pets.
- WARNING! Do not leave packaging material lying around carelessly. This may become dangerous playing material for children. Risk of suffocation!
- This device is intended for domestic and private use and its intended purpose only. The device is not
intended for commercial use. All other uses are deemed to be improper and may result in damage to property or even personal injury.
General Safety information and instructions
- Read the instructions for use carefully and keep them safe. If you give this device to other people, please also pass on this manual.
- Only use this device in accordance with the instructions in this user manual.
- Do not place the device under any mechanical stress.
- Please handle the device carefully. Jolts, impacts or falls, even from a low height, can damage the device.
- Prior to use, check the device for visible external
- Please handle the device carefully. Jolts, impacts or falls, even from a low height, can damage the device.
- Prior to use, check the device for visible external damage. Never operate the device if it is damaged.
- Do not open the casing as this may result in an electric shock.
- Do not attempt to disassemble or repair the device or modify it in any manner.
- The chime’s LEDs cannot be replaced.
- Repairs must only be carried out by a qualified technician. Never attempt to repair the device yourself.
- Improper repairs can pose significant risks to the user and will invalidate any warranty claims.
- The guarantee will expire immediately if damage has been caused by non-compliance with this user manual.
- The manufacturer accepts no liability for damage caused by non-compliance with the user manual, negligent use or use that does not comply with the conditions of this user manual
- This device is not a toy and should be kept away from children and pets.
- Do not allow unsupervised children to clean or maintain this device.
- To avoid damage, never immerse the device in water or any other liquid.
- This device is intended for domestic or similar use and should never be used for anything other than its intended purpose.
- If you give the device to a third party, also supply the user manual.
- Retain the device’s user manual and packaging.
Batteries and heat
- Do not open the casing as this may result in an electric shock.
- Do not place the device close to products that become hot.
- If the battery leaks, do not allow any battery fluid to come into contact with the skin or eyes. If contact has been made, wash the affected area with copious amounts of water and seek medical advice.
- Keep batteries out of reach of children.
- Do not short-circuit the contacts inside the battery compartment or any batteries.
- Do not crush, puncture, or dismantle the device, otherwise, it might damage the batteries.
- Do not dispose of the device in a fire because the batteries could explode.
- Do not expose the device and batteries to excessive heat sources like fire.
- Do not dispose of the device in your household waste, as it contains batteries. Batteries can be disposed of by taking them to your local recycling station. Contact your local
government offices for details.
INSTALLING AND USING THE DEVICE
Open the packaging carefully before taking out the device. Make sure its
complete and undamaged. If any components are missing or damaged, contact the
vendor and do not use the product. Retain the packaging or recycle it in
accordance with local regulations.
- Remove all packaging from the device.
- Clean the device with a damp cloth. Please refer to the ‘cleaning and maintenance section.
Parts and features
- Melody selection button
- Volume button
- Mode selection
- Ringer button
- LED light
- Nameplate
- mounting plate
Inserting batteries Ringer
- Detach the mounting plate from the ringer.
- Open the round battery cover (10) of the device with a coin.
- Turn the battery cover counterclockwise to open it.
- Insert 1 x 3Vdc CR2032 battery (included), observe the secure battery cover, and turn it clockwise.
Note: If the battery needs to be replaced after mounting the device, first detach the ringer from the mounting plate, then follow the steps as described above.
Operating Instructions pairing the ringer and chime
- Press and hold the melody selection button (1) on the chime for 3 seconds until you hear two short beeps.
- Press the button of the ringer (5) within 30 seconds. Two short beeps will sound, indicating the ringer is paired with the
- Melody – upper position switch
- LED flash – middle position switch
- Melody & LED flash – bottom position switch
Installation ringer
Mounting with adhesive tape The ringer can be mounted by using the included
adhesive tape on the rear surface of the mounting plate. Adhesive tape can
only be used on a dry and smooth surface, which is free of dirt and grease. In
order to prepare the surface for putting the adhesive tape on the mounting
plate, wipe the surface with a cloth soaked in degreaser, then wipe it dry
before placing the mounting plate with the adhesive tape.
Mounting with screws & plugs
If you intend to install this device yourself, you must check for
installations such as electrical wiring and plumbing that may be hidden inside
the wall. Additional tools (not included) are required for installation. Mark
the drill holes at the marked positions (holes) of the mounting plate. Drill
the holes and push the mounting plugs into the drilled holes. Then use the
screws to assemble the mounting plate. Do not over-tighten screws. Attach the
ringer to the mounting plate. Installation chimes The portable chime can be
placed in any desired location. It is possible to mount the chime. Check the
correct operation before drilling any hole. To mount the chime, drill a hole
at the desired position and push the mounting plug into the drilled hole. Then
use the
screw to slide the chime over the mounted chime.
CLEANING AND MAINTENANCE
Proper and regular cleaning will ensure safe operation and extend the lifespan
of the device. Use a damp cloth to remove dirt from the device.
Attention!
- Do not clean the device with strong chemicals – or alkali-based, abrasive or disinfecting agents – because they could damage the surface of the product.
- Do not immerse the device in water or any other liquids.
TECHNICAL SPECIFICATIONS
- Frequency: 433,92 Mhz
- Input ringer: 3Vdc CR2032 battery
- Input chime: 3Vdc 2x AA battery
- Ringer: IP44
- Dimensions ringer: 3.9 x 9.4 x 2.2 cm (L x H x D)
- Dimensions chime : 7 x 12.4 x 2.3 cm (L x H x D)
- Net weight Ringer: 43 gram
- Net weight Chime: 89 gram
All contents and specifications mentioned in this manual are subject to change without prior notice.
INSTRUCTIONS FOR PROTECTING THE ENVIRONMENT
(WEEE, the waste electrical and electronic equipment directive)Your product
has been manufactured using high-quality materials and components which can be
recycled and used again. At the end of its life span, this product cannot be
disposed of in normal domestic waste but must be taken to a special collection
point for recycling electrical and electronic equipment. This is indicated in
the user manual and in the packaging by the waste container marked with a
cross symbol. Used raw materials are suitable for recycling. By recycling used
appliances or raw materials, you are playing an important role in protecting
our environment. You can ask your local council about the location of your
nearest collection point.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>