TELESIN S1-CSS-01-TGP Rechargeable Shorty Tripod With Remote Control User Manual
- August 28, 2024
- TELESIN
Table of Contents
**TELESIN S1-CSS-01-TGP Rechargeable Shorty Tripod With Remote Control User Manual
**
Foreword
Thank you for purchasing Telesin product.
Important Notes
- Before using this product, read this manual carefully.
- Keep the manual properly. If other users want to use this product, give this manual with the product.
- Note all the warnings and follow all the instructions provided in this user manual.
- Do not disassemble the product. If the product is deformed or gets wet, immediately stop all use.
- Do not cover the product with towels, clothing or other items during charging to avoid fire.
- Avoid dropping the product. Do not use it in excessive temperature or short circuit situations.
- Keep out of reach of children
Warnings
Do not disassemble the product or change its battery. If you have any questions, please contact the seller to apply for after-sales service.
Mounting
Mount your camera to shorty using the top mounting fingers.
- You can swivel or tilt your camera to adjust the capture angle.
WARNING
Shorty is not weather resistant when used as a wireless remote or any time
the USB-C cable is disconnected from your camera.
Power On and Bluetooth Pairing
Press and hold the Power button on 3 seconds to power on. Shorty will
automatically begin pairing.
The LED will blink blue while it’s searching for the camera and turn solid
blue when it’s connected.
Switch Camera Mode
Press the Mode button to cycle the mode that you want.
Time-lapse Mode Video Mode Photo Mode
Start Capturing
- Press the Shutter button to start capturing.
- Mark favorite moments by pressing the Mode button on the remote during recording.
- When the connected camera is nearby, press the Shutter button to turn on the camera and start capturing.Press the Shutter button again to end.
Entering Quick Record Status
Press and hold the Mode button for 5 seconds to enter the Quick Record state and turn off the camera. Press again for 5 seconds to exit the quick recording state, and the camera will power on to resume the normal state.
Reset Pairing
Press and hold Mode button Power button for 3 seconds to reset pairing
Charging
Plug the charging cable into the charging slot. Connect the other end of the cable to a computer or other USB power source.
Charging Time: 2.5h
Battery Capacity: 5000 mAh
Input/Output Port: USB-C
Power Input: 5V 2A, 9V 1.5A, 12V 1A
Power Output: 5V 2A, 9V 1.5A, 12V 1A
*The data are measured by Telesin Lab but may vary based on specific circumstances.
Warning
Hazard warnings:
A product that contains button or coin batteries must display a warning
message:
“Warning: Contains button or coin cell battery. Hazardous if swallowed –
see instructions”
“Keep out of reach of children. Swallowing can lead to chemical burns,
perforation of soft tissue and death. Severe burns can occur within 2 hours of
ingestion. Seek medical attention immediately.”
All electric toys using replaceable button or coin batteries shall state the
following warning in the instructions:
“Warning: Dispose of used batteries immediately. Keep new and used
batteries away from children. If you think batteries might have been swallowed
or placed inside any part of the body, seek immediate medical attention.”
FCC Caution
15.19 Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject tthe
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any infterference received, including
interference that may cause undesired operation.
15.21 Information to user.
Any Changes or modifications not expressly approved by the partyresponsible
for compliance could void the user’s authority to operate the equipment.
15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limitsfor a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection againarmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
Howvever, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harnnful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit differentt from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
* RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
IC Caution
This device complies with Industry Canada´s licence-exempt RSSs. Operation is
subject to the following two conditions:
(1) This device may not cause interference;
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Disclaimer
Please read this statement carefully and by using this product you will be
deemed to have acknowledged and accepted it in full. Please check the product
carefully before each use and do not use it if damaged or deformed. By using
this product, you acknowledge and agree that you are fully responsible for
your actions and the possible consequences of using this product.You undertake
to use this product only for legitimate and lawful purposes. You understand
and agree that Telesin Digital Co.,Ltd (“Telesin”) shall not be liable for any
misuse, adverse effects, damages, injuries, penalties or other legal
consequences arising directly or indirectly from the use of this product. The
user should follow the precautions including but not limited to those
mentioned herein. To the extent Telesin reserves the right to interpret and
modify this commitment within the limits of national laws and regulations.
*The warranty period for TELESIN products begins 6 months on the day you receive the product.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>