Marshall CV-MICRO-JYSTK Micro Joystick Controller Instructions
- June 3, 2024
- Marshall
Table of Contents
Marshall CV-MICRO-JYSTK Micro Joystick Controller
Quite simply – the simplest joystick ever!
All functions are controlled with the CV-MICRO-JYSTK in three modes:
- Pan & Tilt
- Zoom & Focus
- Menu Scroll & select
The modes are changed with the touch-down switch on the joystick. You can
either tap the switch or hold down the switch.
A tap is less than 0.5 second
- A hold down is more than 0.5 second
- The joystick powers up in Pan & Tilt mode. To toggle between Pan & Tilt mode and Zoom & Focus mode, just tap the joystick switch.
- To enter Menu, Scroll mode, hold down the joystick switch. Then use the joystick to navigate the menu.
- To exit Menu, Scroll mode, hold down the joystick switch.
Connections
DC jack : 12 – 35v
XLR4: on a flying lead. This has both power & data for a remote head.
There is a connector on the PCB inside which can be used to connect a Remote
Camera Panel or other equipment into the system. When data is being received
the LED will flash.
Note: Not all functions apply to all camera models. Check camera
specification for applicable functions.
Function List
Home Menu
- Pan & Tilt Control
Tap: Zoom Focus Menu
- Zoom & Focus
Hold Down: Menu Scroll
- Joystick up/Down to Scroll
- Joystick Left/Right to change value
Head Functions
- Pan Gear
- Tilt Gear
- Josytick Ramp (Ramp up & Ramp down together)
- Head Select 1 – 32
- Preset Store
- GoTo Preset
- Tally On/Off
- Set Home
User Setup
- Change Head ID.
- Reset Head to Factory
- Calibrate Joystick
- Head Reverse. Pan/Tilt directions, Swap Iris & Focus, reverses Zoom and Focus directions
- Select Camera Model – Marshall / Dreamchip
- Camera Format – HD/4K, 24/25/29.95/50/60, i/p etc.
- Reset ALL Heads to ID #01
CCU Functions
- Iris – Auto / Manual / Adjust
- Gain
- Shutter
- Dynamic Noise Reduction (DNR
- Detail
- Gamma
- Master Pedestal (MPED)
- White Balance – Push, Manual, Full Auto White, 3/k2, 5k6
- Red Gain
- Blue Gain
- Auto Focus On/Off
Note: Not all CCU functions are available on all cameras. Check camera data sheet for available functions. Further CCU functions are available but require a Remote Camera Panel. Ask your dealer or visit website for details.
www.marshall-usa.com
Tel: 800-800-6608
support@marshall-usa.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>