Anker A91B2 Power Strips and Outlet Extenders User Guide

August 28, 2024
Anker

Anker A91B2 Power Strips and Outlet Extenders

Specifications

  • Product Number: A91B2 51005004828 V01
  • Compliance: FCC, IC, RSS-GEN
  • Distance Requirement: FCC – 20cm, IC – 10cm
  • Warranty: Connected Equipment Warranty

Product Information

This device complies with FCC and IC regulations regarding  radiation exposure limits. It contains license-exempt transmitter(s)/receiver(s) in accordance with Innovation, Science, and Economic Development Canada’s regulations. The equipment should be installed and operated with a minimum distance of 20cm (FCC) or 10cm (IC) between the product and the user’s body to ensure compliance.

Product Usage Instructions

Installation

  1. Place the product on a stable surface.
  2. Ensure there is a minimum distance of 20cm (FCC) or 10cm (IC) between the product and your body.
  3. Connect the necessary cables according to the user manual.

Operation

  1. Power on the device using the designated button.
  2. Follow the on-screen instructions or refer to the user guide for setup.
  3. Use the device within the specified distance limits to comply with regulations.

Maintenance:

  1. Keep the device clean by wiping it with a soft, dry cloth.
  2. Avoid exposing the device to extreme temperatures or moisture.
  3. Refer to the user manual for troubleshooting and maintenance tips.

FAQ

Q: What should I do if the device is not powering on?

A: Check if the device is properly connected to a power source and try a different power outlet. If the issue persists, contact customer support for assistance.

Q: Can I use the device closer to my body than the specified distance?

A: To ensure compliance with regulations and minimize radiation exposure, it is recommended to maintain the specified distance between the device and your body at all times.

Important Safety Instructions

  • Do not connect this product to an outlet that is not grounded.
  • Do not use with extension cords.
  • Use this product only in dry locations and indoors.
  • Do not daisy-chain this product with other power strips.
  • Keep this product out of reach of children.
  • In the event of failure or a component defect, this product should not be repaired by service personnel. Dispose of this product in accordance with local environmental protection regulations.
  • The surge protection feature safeguards your devices against voltage fluctuations, surges, and spikes. If the Surge Protection indicator is off, it signifies that the protection is not active.
  • Ensure that the socket-outlet is easily accessible at all times.

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

The following importer is the responsible party:
Company Name: Fantasia Trading LLC
Address: 5350 Ontario Mills Pkwy, Suite 100, Ontario, CA 91764
Telephone: 1-800-988-7973

Radiation Exposure Statement
This equipment complies with FCC Radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the product and your body.

IC Statement
This device complies with Industry Canada license-ICES-003. Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device.

RSS-GEN
This device contains licence-exempt transmitter(s)/receiver (s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

  1. This device may not cause interference
  2. This device must accept any interference, Including interference that may cause undesired operation of the device.

IC RF exposure statement:
This equipment complies with IC Radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 10cm between the product and your body.

Connected Equipment Warranty
Anker Innovations Limited (“Anker”) offers a limited Connected Equipment Warranty (CEW) for Anker Power Strips and Outlet Extenders as listed below. The product shall be purchased originally from Anker and free of defects in design, assembly, material, or workmanship. Anker reserves the right to update, amend, and/or revise the terms of this CEW.
For more details about the CEW, please refer to the official website: https://us.anker.com/pages/connected-equipment-warranty Or scan the QR code below:

USER GUIDE

For tutorial videos, FAQs, manuals, and more information, please visit: https://support.anker.com

Or scan the QR code below:

Product Number: A91B2
51005004828 V01

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals