SKYZONE TX2501 CNC 2.5W 5.8G L.X Band VTX Instructions
- August 28, 2024
- SkyZone
Table of Contents
TX250 CNC 5.8G 2.5W VTX
The TX2501 is powerful VTX which have 2.5W output, the new CNC case and fan can dispath the heat quickly , LED segment make the VTX easy to set and check the BAND/CH/POWER, its also support X Band(5G Hz) and Low Band.
Features:
- Support X Band(5G Hz) and Low Band
- CNC Case dan Fan to dispatch heat
- 25/800/1600/2500mW adjustable power output
- 7-26V Wide Range Voltage input
- LED Segment Display, easy to check status of the VTX
- Button/IRC control, fast to change the CH and Power
- Allow use customized frequency 1Mhz by 1 Mhz from 4990~5945
Notice:You can only choose one of the Button mode and the IRC mode. If
you use the button mode, you need to turn off the IRC protocol in BF. The LED
segment displays the BAND/CH and power in sequence in the button mode, and the
frequency and power at IRC mode.
Power Output at X Band
X | 4990M | 5020M | 5050M | 5080M | 5110M | 5140M | 5170M | 5200M |
---|---|---|---|---|---|---|---|---|
Power | 1W | 1.2W | 1.4W | 1.5W | 2W | 2.2W | 2.4w | 2.5W |
Power Level
| | |
---|---|---|---
25mW| 800mW| 1600mW| 2500mW
Frequency Table
Band | CH 1 | CH2 | CH3 | CH4 | CH5 | CH6 | CH7 | CH8 |
---|---|---|---|---|---|---|---|---|
A | 5865M | 5845M | 5825M | 5805M | 5785M | 5765M | 5745M | 5725M |
B | 5733M | 5752M | 5771 V | 5790M | 5809M | 5828M | 5847M | 5866M |
E | 5705V | 5685M | 5665V | 5645M | 5885M | 5905M | 5925M | 5945M |
F | 5740M | 5760M | 5780M | 5800M | 5820M | 5840M | 5860M | 5880M |
R | 5658M | 5695M | 5732V | 5769M | 5806M | 5843M | 5880M | 5917M |
L | 5362M | 5399M | 5436V | 5473M | 5510M | 5547M | 5584M | 5621M |
X | 4990M | 5020M | 5050V | 5080M | 5110M | 5140M | 5170M | 5200M |
Wiring Diagram
How to manually set the VTX
Disable the IRC protocol on betaflight UART tab.
Step 1: hold button for 3 seconds into BAND setting mode.
Step 2: Under BAND setting mode, short press the button to change BAND ,
long press button 3s to enter CH setting mode.
Step 3: Under CH setting mode, short press the button to change CH, hold
button 3s to enter the Power setting mode.
Step 4: Under Power setting mode , short press to adjust the power, and
long press for 3 seconds to save.
https://www.qrfy.com/D4ePo0Hv_q